Connecting Throttle Cable; Installing Debris Shield - Maruyama E270 Manual Del Propietario U Operador

Connecting Throttle Cable

Cable Adjuster Sleeve
Throttle Cable Housing
Carburetor Bracket
Cable Adjuster
Sleeve
Carburetor Throttle Cam
Slotted Fitting
1. Loosen the knob and remove the air filter cover,
insert the throttle cable through the cable adjuster
sleeve on the carburetor bracket. Make sure the
end of the cable housing is seated positively in the
sleeve.
2. Position the slotted fitting on the carburetor so the
recessed hole for the cable lug is away from the
cable adjuster sleeve.
3. Rotate the carburetor throttle cam clockwise and
slip the throttle cable through the slot in the
slotted fitting, making sure the cable lug drops
into the recessed hole.
4. Operate the throttle trigger a few times to make
sure that it works correctly.
5. Adjust the cable adjuster sleeve so the stop on the
carburetor throttle cam just contacts the throttle
stop when the throttle trigger is fully depressed.
6. When the throttle cable is adjusted correctly,
tighten the locknut.
7. Reinstall the air filter cover and tighten the knob.
Locknut
Throttle Cable
Slotted Fitting
Recessed
Hole
Cable
Lug
Throttle Stop/Idle Speed
Adjuster Screw Bracket
Idle Speed
Adjustment Screw
— US-11 —

Installing Debris Shield

WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by the
Edger.
WHAT CAN HAPPEN
• Contact with thrown objects can
cause personal injury.
HOW TO AVOID THE HAZARD
• Never operate the Edger without the
blade shield in place.
Debris Shield
Shield Stud
Hex
Nut
Lock
Washer
Flat Washer
Collar
Plate Stud
Install the collar onto the plate stud.
1.
2. Install the shield onto the plate stud, making sure the
shield stud fits into the matching slot in the plate.
3. Install the flat washer, lock washer and hex nut onto
the plate stud.
4. Install the flat washer and knob onto the shield stud.
Plate
Flat Washer
Knob