Assembly; Assembling Engine And Shaft Assembly; Loop Handle Installation; Connecting Stop Switch Wires - Maruyama E270 Manual Del Propietario U Operador

Assembly

Assembling Engine and Shaft
Assembly
The shaft assembly, clutch drum housing and gearcase
are assembled. Attach the clutch drum housing to the
engine using the four M5 x 20 screws supplied with the
unit.

Loop Handle Installation

Screw (4)
Nut (4)
Engine
M5 x 20 Screw (4)
Shaft Assembly
Clutch Drum Housing
(A)
Loop Handle
Shaft Assembly
Rubber Sleeve
Bottom Clamp
Loop handle must be assembled gearcase side from
the arrow (A).
1. Slip the rubber sleeve around the shaft assembly.
2. Rotate the rubber sleeve so the split is to one side.
3. Place the loop handle and the bottom clamp over
the rubber sleeve.
4. Install the four screws and nuts. Leave the screws
finger-tight.
5. Reposition the loop handle up or down the shaft
assembly to the most comfortable position, but
don't over to the arrow mark.
6. Tighten the screws and nuts.

Connecting Stop Switch Wires

Shaft Grip
Stop Switch Wires
1. Install the plastic tube (packed with the shaft
assembly) around the throttle cable and stop
switch wires.
2. Plug the stop switch wires into the matching
connectors from the engine. Note that wire
polarity is not important.
— US-10 —
Plastic Tube
Stop Switch Wires
Throttle Cable
Air Filter Cover
Knob