Technical Data - Einhell Global SB 501 Manual De Instrucciones

GB
Watch out for other persons
Watch out for other persons (especially children)
when using the device, and keep them away from
your work area. Do not let anyone touch the device
or the power cable.
Store the tools in a safe location
Store unused devices in a dry, locked location that is
out of the reach of children.
Avoid overloading the device
Operate the device only within the specified output
range. Do not use any low-powered machines for
heavy duty work. Do not use tools to perform work
for which they were not intended.
Maintain a steady foothold
Ensure that you maintain a steady foothold while
working. Avoid abnormal body positions and always
keep your balance.
Pull out the mains plug
Pull out the mains plug when not using the tool, prior
to maintenance, and when changing the drill bit.
Avoid unintentional start-up
Ensure that switch is turned off when plugging the
plug into the socket.
Keep an eye on your work
Always keep an eye on your machine and the object
you are working on. Never use the machine when
you are not concentrating or are distracted. Never
use the machine when you are under the influence of
alcohol or are taking medication.
Check the tool for damage
Before using the tool, safety devices and any slightly
damaged parts must be carefully checked to ensure
that they are in good working order. Visually examine
the tool's power cable on a regular basis. All parts
must be correctly assembled and meet all the
conditions required to ensure proper operation.
Unless otherwise specified in the operating
instructions, any damaged safety devices and parts
must be properly repaired or replaced by a
professionally recognized workshop. Never use tools
with defective On/Off switches.
Warning! Using any plug-in tools and accessories
other than those specified in these operating
instructions can lead to injury.
12
Now, please read and follow all steps and
procedures included in the operating
instructions.

5.0. Technical data

Nominal input voltage
Nominal output
Operating mode
Nominal idle speed
Speed levels
Drill chuck mount
Scroll chuck
Max. shaft diameter
Reach
Drill depth
Pillar diameter
Height
Weight approx.
Technical and visual enhancements may be made
without prior notice. All dimensions, notes and
specifications contained in these operating
instructions are therefore subject to change.
Noise/vibration
Sound pressure level LpA: 75.5 dB (A) at idle and
78.7 dB (A) in operation.
Hand/arm vibration is typically less than 2.5 m/s
Noise and vibration were determined in accordance
with prEN 61029-1 requirements.
6.0. Set-up
6.1. Assembly (Fig. 1-3)
Assemble the machine as follows:
b Position the machine base (1).
b Fasten the mounting flange with pillar (2) to
machine base (1) using three screws (3) and
washers.
b Push the drill table (4) with drill table clamp shaft
onto the pillar (2) (Fig. 3).
b Lock the drill table into the desired position using
the clamping screw (5).
b Place the drill head (6) with V-belt cover (7) and
motor (8) onto the drill pillar and fasten using the
grub screw (20).
b Screw the three ball-shaped handles (9) onto the
feeder cross handle.
230V ~ / 50 Hz
400 Watts
S6 50 %
280 - 2,350 min -1
9
B 16
Ø 1.5 - 16 mm
16 mm
115 mm
50 mm
46 mm
610 mm
22 kg
2 .