Items Supplied; Proper Use; Safety Information - Einhell Global SB 501 Manual De Instrucciones

1.0. Layout (Fig. 1/2)
1. Machine base
2. Pillar
3. Fixing screw
4. Drill table
5. Clamping screw
6. Machine head
7. V-belt
8. Motor
9. Grip knobs
10. Scroll chuck
11. Spindle
12. Mounting holes
13. Hinged chip guard
14. Vise
15. Tightening screw
16. Screw
17. Clamping screw
18. On button
19. Off button
20. Grub screw

2.0. Items supplied

b Pillar drill
b Scroll chuck
b Drill chuck key
b Hinged chip guard
b Vise

3.0. Proper use

This table drilling machine is designed for drilling
metal, plastic, wood, and similar materials.
Neither food nor materials that present a health
hazard may not be processed with the machine. The
drill chuck is only designed for use with drill bits and
tools with a shaft diameter of 1.5 to 16 mm, and for
cylindrical tool shanks. The device is for adult use
only. The machine is designed for continuous
operation with intermittent load (S6 50 %). Any use
of the machine other than that stipulated in these
operating instructions releases the manufacturer
from all liability and voids all warranty claims.

4.0. Safety information

The pillar drill was designed in such a way so as to
all but eliminate potential hazards when the machine
is properly used. However, there are a few safety
precautions to observe in order to ensure that all
residual hazards are ruled out.
Ensure proper voltage
The voltage must comply with the specifications on
the rating plate.
Use a socket-outlet with earthing contact
The device may only be operated from an outlet with
the properly installed earthing contact.
Extension cable
The cord cross section of an extension cable must
measure at least 1.0 mm_. Always completely
unwind a cable reel prior to use. Check the cable for
defects.
Protection against electrical shock
Keep the device away from moisture. The device
must neither be damp nor be operated in a humid
environment. Prior to every use, check the device
and the mains cable with plug for damage. Avoid
bodily contact with earthed parts e.g. pipes, hot
elements, etc.
Protection against fire and explosion
There are spark producing components inside the
device. Do not use the device in the vicinity of
combustible liquids or gases. Otherwise there is a
risk of fire or explosion.
Handle the device with care
Do not use the cable to pull the plug out of the
socket. Protect the cable from heat, oil and sharp
edges. Keep your tools sharp and clean so that you
can work efficiently and safely. Follow the
maintenance regulations and the instructions for
changing tools.
Wear suitable work clothes and personal
protection equipment
Loose clothing is not suitable, as it can be caught by
moving parts, causing you to become entangled.
Wear a hair net if you have long hair. As a general
rule, jewelry should not be worn when working with
machine tools. Ensure that you wear safety goggles.
Not doing so could result in eye injury.
Keep your work area neat and tidy
Disorder in the work area can easily lead to
accidents. Do not leave any tools, objects, or cable in
the direct vicinity of the work area, as this poses a
tripping hazard! Ensure that there is sufficient
lighting.
GB
11