Installation - Siemens HiPath Instrucciones De Montaje

Installation

Prerequisite: One operational OpenStage T system telephone.
The PhoneAdapter is installed between the phone and the connection cable.
This is a front view of the PhoneAdapter:
a/b
Analog out-
put socket
7 . Connect the power supply unit to the power source and plug the other end into the
Q
socket in the PhoneAdapter.
8. Place your OpenStage phone on a soft surface with the keyboard facing downwards.
9. Remove the cable from the
socket" on the PhoneAdapter.
10. Using the supplied cable, connect the
"U 0 Master output socket" on the PhoneAdapter.
p
Your phone is now operational again.
11. Push the "Analog/U
phone or to the left if you want to attach an analog terminal.
12. Now connect the additional device as follows using the second cable supplied.
Connection of an additional U
Using the supplied cable, connect the
socket" on the PhoneAdapter
or
Connection of an analog terminal:
Connect the terminal to the "Analog output socket" on the PhoneAdapter. Use a cable sui-
table for the analog device (max. length of 10 meters). Only cables with a suitable western
jack (e. g. not TAE) can be used. You may be able to use the cable supplied with the Pho-
neAdapter, see "Characteristics of the a/b interface"
You must connect an OpenStage phone to the "U
able to operate devices on the "U
Switch
analog/Up0 Slave
Up0 Slave out-
put socket
socket on your phone and plug it into the "u
0 Slave" switch to the right if you want to connect a further U
p
0 system telephone:
p
socket on the telephone to the "U
0 Slave" and "Analog" output sockets.
p
u 0 u 0 u
p p
Up0 Master
output socket
input socket
socket on your OpenStage phone to the
Seite 14.
0 Master" socket in order to be
p
Installation
0
Q
p
Power supply
unit
Up0
0 input
p
0 Slave output
p
0
p
13