Tabla de contenido
3
SW1 : Programming button
• Apartment terminals programming is always done from the panel
activated as MASTER.
• Any installation can only have one MASTER panel at a time,
whether a single or multiple block installation, once configured as
a sub-block, block or general entrance.
• A street panel is configured as a MASTER via the SW1 amplifier
button. If the SW1 button is pressed 3 times quickly, it is activated
as a MASTER panel and a confirmation tone sounds (beep-
beep), after 2 seconds.
• When a panel is selected as MASTER, it notifies the rest of
the situation and if another was previously configured, it would
automatically stop being so.
• If there are various blocks in an installation, we recommend using
the general entrance panel as MASTER since it allows you to
program all of its telephones/monitors.
• Once having completed the terminal´s configuration, we
recommend deactivating the MASTER panel to avoid accidentally
reprogramming terminals.
• The panel deactivates itself from master mode following the
same activation procedure: 3 quick presses of the SW1 button. A
deactivation tone sounds (bip-bop), after 2 seconds.
Pag 16
MASTER Panel:
Tabla de contenido
