Legal Information - Ottobock 50P70 Manu Carezza Instrucciones De Uso

► Instruct the patient to see a physician immediately if any excep­
tional changes are noted (e.g. worsening of the complaint).
4.1 Size selection
The support is available in one universal size and can be worn on
either side. The maximum wrist circumference is 22 cm.
4.2 Fitting and Application
CAUTION
Incorrect or excessively tight application
Skin irritation due to overheating, local pressure points due to tight
application to the body
► Ensure that the product is applied properly and fits correctly.
► When in doubt, do not continue to use the product if skin irrita­
tion occurs.
The support is pre-configured for use on the right hand upon delivery.
To use it on the left hand, change the direction of the thumb closure
loop on the support (see fig. 1).
1) Unroll the support; the hook-and-loop closure for the thumb
remains fastened.
2) Guide the thumb through the thumb opening (see fig. 2).
3) Guide the wide hook-and-loop closure of the support over the
back of the hand and fasten it at the wrist (see fig. 3).
4) Check the fit of the support and use the hook-and-loop closures
to optimize the fit of the support if desired (see fig. 4).
→ The support fits snugly without pinching.
4.3 Removal
1) Open the hook-and-loop closure of the support; the hook-and-
loop closure for the thumb remains fastened.
2) Remove the support.
8
5 Cleaning
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
► Only clean the product with the approved cleaning agents.
1) Fasten all hook-and-loop closures.
2) Recommendation: Use a laundry bag or net.
3) Wash the support in warm water at 40 °C (104 °F) with standard
mild detergent. Do not use fabric softener. Rinse thoroughly.
4) Allow to air dry. Do not expose to direct heat sources (e.g. sun­
light, stove or radiator).
6 Disposal
Dispose of the product in accordance with national regulations.

7 Legal Information

All legal conditions are subject to the respective national law of the
country of use and may vary accordingly.
7.1 Liability
The manufacturer shall be liable in the event that the product is used
in accordance with the descriptions and instructions in this document.
The manufacturer will not assume liability for damage caused by disre­
garding the information in this document, particularly due to improper
use or unauthorized modification of the product.
7.2 CE Conformity
The product meets the requirements of Regulation (EU) 2017/745 on
medical devices. The CE declaration of conformity can be download­
ed from the manufacturer's website.