Troubleshooting; Troubleshooting Chart; Fcc And Ic Compliance Statement - Briggs & Stratton Allmand NIGHT-LITE GR Serie Manual Del Operario

Electrical
Automatic Lighting - Automatically turns lights on after engine
Sequenced Lighting System start and delays engine shutdown to turn off
(SLS) lights first to prevent generator from shutting
down under load.
Note: Not available with generator
disconnect.
Available Outlets
20A 120V duplex GFCI outlet (NEMA 5-20R)
Engine
Specification
Model Yanmar
Type Air-Cooled Single Cylinder Diesel
Displacement 20 cu in
Aspiration Naturally aspirated
Emissions EPA Tier 4 Final
Power Output - Prime 5.8 Hp @3600 rpm
Fuel System Direct fuel injection
Starting Aid Intake heater
Engine Electrical System 12 Volt DC
Engine Alternator 15 A
Number of Batteries 1
Battery Size Group 24
Battery Type Standard - lead acid
Battery Rating 525 CCA @ 0°F (-18°C)
Automatic Low Oil Pressure 7 PSI
Shutdown
Fuel North America - diesel fuels that meet ASTM
D975 for Ultra Low Sulfur Diesel (ULSD)
are required. ULSD has a maximum sulfur
content of 15 parts per million (PPM) or 15
mg/kg. Diesel fuel may be No. 1-D or No.
2-D. Refer to Engine Operator's Manual for
detailed information.
Required Engine Oil Type 5W-40, CK-4 Certified Full Synthetic
Recommended Engine Oil MAG 1®
Brand
Engine Oil Capacity - with 3.25 US qts
Filter
Service Interval - Oil Change First Oil & Oil Filter Change - 50 hr
& Filter
All Other Oil & Oil Filter Changes - 1,000 hr*
Service Interval - Fuel Filter 500 hrs
Service Interval - Air Filter Refer to Engine Op Manual
Service Interval - Valve Lash 500 hrs
Engine oil must be checked prior to
Note*
operation and refilled if necessary

Troubleshooting

DANGER
Electrocution Hazard
• High voltage is present when engine is running. Never
attempt to service electrical components while engine is
running.
• Contact with wires made bare by damaged, cut or
worn insulation could result in death or serious injury.
Replace damaged wiring before operating unit.
24
Imperial Metric
320 cc
4,3 kWm @3600 rpm
48 kPa
3,0 L
Before trying to do any troubleshooting, read Safety.
For engine and generator troubleshooting, refer to the Engine
Operator's Manual and Generator Operator's Manual, or
contact your dealer.

Troubleshooting Chart

Problem Possible Cause
Light(s) not Breaker(s) in outlet box not
operating turned on or tripped.
Connection between light bar
and fixture(s) not secure.
Too much power being drawn
from auxiliary outlets.
For all other issues, contact your authorized dealer.
FCC and IC Compliance
Statement
FCC Part 15 Information To User
Pursuant to part 15.21 of the FCC Rules, you are cautioned
that changes or modifications to the product not expressly
approved by Briggs & Stratton could void your authority to
operate the product.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
IC Information to User
This device complies with Industry Canada's license-exempt
RSSs. Operation is subject to the following two conditions:
1. This device may not cause interference; and
Remedy
Turn on / reset breakers.
Check and secure connections.
Remove load(s) from auxiliary
outlets.
www.allmand.com