Cleaning And Care - Clatronic HPS 2777 Profi Instrucciones De Servicio/Garantía

5....-05-HPS 2777 Profi
Initial and General Use of the Hair Dryer
GB
1. Fully unwind the mains cable.
2. Attach a nozzle if required. You can dry single hair locks by concentrating the
flow of hot air with the hairdressing nozzle.
3. Insert the plug into a duly installed 230V/50Hz protective contact socket.
4. Shift the switch on the handle to one of the desired heat/blowing levels:
Level 0: off
Level 1: medium airflow and medium temperature
Level 2: strong airflow and high temperature
5. After use shift the switch to position 0 and pull out the plug. Leave the device to
cool before putting it away!
COOL-Shot:
With this switch it is possible to interrupt the heating process so that the air can be
mixed according to individual requirements.
Initial and General Use of the Curling Tongs
1. Fully unwind the mains cable.
2. Ensure that the round brush is fixed firmly in place.
3. Insert the plug into a duly installed 230V/50Hz protective contact socket.
4. When your have dried your hair with a towel (no longer wringing wet), turn it
evenly around the round brush or shape your hair with the curler switched on as
desired.
The curling tongs will put your hair back into shape.
5. Setting the Temperature Level
Position 1:
Position 2:
6. In order to unwind a curl, press the button above the operating switch.
7. After use, turn the switch to the "0" position and then remove the mains plug.
Allow the device to cool down before storing it away!
Hair dryer
Removing the air suction cover:
• Remove the cover after turning the cap through approximately 10 degrees
against a clockwise direction.
• Clean the air suction opening from time to time with a fine brush.
• Clean the housing with a soft, dry cloth without additives.
Curling tong
• Clean the air suction opening from time to time with a fine brush.
• Clean the housing with a soft, dry cloth without additives.
• In order to remove this, take hold of the handle and pull the round brush off.
26
18.02.2003 10:35 Uhr
medium temperature for gentle drying and shaping
high temperature for rapid drying

Cleaning and care

Seite 26