Technical Specifications; Technical Data; Description Of The Machine; Principal Elements Of The Structure - Sagola DOBLE 250 Manual De Instrucciones

5.1. TECHNICAL DATA

Weight: 130 Kg.
Height: 1,515 mm.
Width: 1,280 mm.
Depth: 650 mm.
Sustainable load on levels: 20 Kg.
Capacity of water-side washing tank: 58 L
Capacity of solvent-side washing tank: 50 L
Capacity of water-side collection barrel: 80 L
Air pressure of power supply: 10 bar

5.2. DESCRIPTION OF THE MACHINE

The Double 250 is a machine that has been
manufactured completely in satinized steel AISI
304.
The machine is made up by a right-hand part that
is used for water washing and a left-hand part for
solvent washing, whose characteristics are
shown as follows:
The right-hand part, with the water washing, is
made up by two 3 tanks:
a) Upper tank used for manual washing of parts,
containing a working grid on which the clean
objects can be placed. A pneumatic mixer is
located inside the tank that is needed to mix the
flocculant and the dirty paint water.
b) Intermediate tank, called the filtering tank,
where the filter is positioned that stops the paint,
letting the clean water pass into the lower collec-
ting tank.
c) Lower tank, called the collection tank, from
which a pneumatic pump aspirates the filtered
water, allowing it to return to the washing cycle.
This tank is fed upwardly by a filter plate that
respectively supports a fabric filter in non-woven
fabric to allow the filtering of water coming from
the washing tank.
The washing of parts that are dirtied with paint
takes place manually with the atomizer brush.
Inside this cabin (right-hand side), there is an
atomizer brush with a relative drip course, which
allows the cleaning of parts with filtered water as
well as the water coming from the water network.
The left-hand side is suitable instead for automa-
tic washing with guns and various parts using

5. TECHNICAL SPECIFICATIONS

clean solvent. It is completely pneumatic and uses
a double-membrane pneumatic pump in order to
operate. The complete structure is in stainless
steel AISI304.
The lower accommodation of the machine must
contain the two clean and re-circulating solvent
barrels to be used for washing and rinsing. The
automatic washing operations can be carried out
in the top part of the machine, called the tank
level.
The washing feed system is located inside the
tank, where all the aerograph components can
be duly accommodated. Other small objects can
also be positioned and washed inside the tank.
Both the parts are supplied with a fume hood,
which can be excluded on the right-hand side
(water washing);
Another two atomizer guns are available (one is
air and the other is water) for possible use during
the manual cleaning.

5.3. PRINCIPAL ELEMENTS OF THE STRUCTURE

1 - Base
2 - Water side cabin
3 - Solvent side cabin
4 - Water side fume hood
5 - Solvent side fume hood
6 - Tank cover
7 - Drip course brush
8 - Water-side brush controls
9 - Solvent-side brush controls
10 - Water-side tank level
11 - Solvent-side tank level
12 - Water-side tank
13 - Solvent-side tank
14 - Water-side lower door
15 - Solvent-side lower door
16 - Base walls
- 17 -