Tabla de contenido
Idiomas disponibles
Idiomas disponibles
In case of direct connection to the mains, the installer has a connection card inside of
connection box.
2.2.- Fastening the hood
The hood must be centred with respect to the cooking surface, at a minimum height of 650
mm.
Use screws and plugs, but first make sure that they are correct for the type of wall where the
hood is to be fitted.
Before setting Operations, remove the filter panels (Fig.4).
Drill 6 holes A-B-C of Φ 6, shown in (Fig.3).
Insert plugs and screws (Fig.3-A) without tightening completely, in such a manner that the
hood can be supported from them.
Then attach the Hood body to the wall using two internal screws. (Fig.3-C).
Fix the decorative telescopic support (Fig.5-1). Make sure all screws are tight.
Extract version
Using a joining pipe of diameter 150mm, connect output ring (Fig.5-2-A) and the discharge
opening. Secure the connection joints, to avoid air leaks, with self adhesive tape.
If installation is thought with a duct of diameter 120mm, you can install 150 to 120mm duct
reducer.
At the time of joining the hood with extraction duct, double-checked that back draft shutter
is opening and closing correctly.
Filter version
If your installation does not have a discharge opening to the outside, you will have to ask your
supplier for active circular carbon filters, which are supplied as an accessory and are not
included as standard equipment. For mount them, see (Fig.6).
Fix in the wall the plastic bracket just below the decorative telescopic support (Fig.7).
The two pins of the support position have to fit with the holes of the plastic derivation.
You can easily cut the plastic shunt to fit well inside the top of the telescopic cover and the air
outlets are properly aligned with the exhaust grill. (Fig.8).
Using a joining pipe of diameter 150 mm, connect output ring and the plastic shunt.
Secure the connection joints to avoid the air leaks, with self adhesive tape. (Fig.9).
2.3.- Fitting the decorative telescopic cover
Fix the lower part of the decorative telescopic cover with hood body using inner screws
(Fig.5-2-B).
Extend the top of the decorative telescopic cover and secure it to the upper support with
the two supplied screws. (Fig.5-1A).
11
Tabla de contenido
