S&P HED-1800 Manual De Instrucciones página 14

 IMPORTANT FOR FRANCE:
.- Electrical power connection must be made by cutting off the supplied plug and using
an adequate terminal, as shown below.
Mains supply
L
N
.- In damp areas or outdoor installations, the connection terminal should be installed at
least 25 cm above floor level. Make sure the cable does not touch the ground.
4. Use of equipment
 Connect the plug into the power point. Use the switch (Figure 1F), to connect and
disconnect power to the device.
 The led (Figure 1G) indicates if the device is connected.
 With the remote control you can turn on and/or turn off each lamp at a distance. Point
the remote control to the control panel (Figure 1E).
 Using the control panel switches (Figure 1H) it is also possible to turn the lamps on
and off manually.
Model
HED-1800
5. Maintenance

Before carrying out any maintenance work, make sure that the device has been
disconnected from the mains and let the heater cool down for a few minutes.
 This product does not require special maintenance. It needs to be cleaned periodically
to prevent accumulation of dust on the lamps, as this may cause overheating of the
heater. Clean the lamp with a brush and the body of the product with a damp cloth.

The replacement of the lamps must be performed by qualified personnel, so contact the
Official Service network of S&P, to ensure adequate technical assistence.
 Do not immerse the device or spray with water.
 If the appliance is not to be used for any length of time, we recommend returning it to its
original package and storing it in a dry, dust-free place.
Live = Brown
Earth = Yellow-Green
Neutral = Blue
Lamps Lamp power
2 2 x 900W
14
Device cable
Total power
1.800W