Health And Safety; Intended Use; Pre-Start Safety Checks - Belle Group Altrad RT 50 Manual Del Operador

Vibration
Some vibration from the machines operation is transmitted through the handle to the operator's hands. The Belle Group RT range has
been speci¿ cally designed to reduce hand/arm vibration levels. Refer to speci¿ cations & technical data for vibration levels and usage
times (recommended maximum daily exposure time). DO NOT exceed the maximum usage times.
PPE (Personal Protective Equipment)
Personal injury or property damage may be caused by knocks, crushing, slipping, tripping, falling, or by À ying chips due mainly to the
improper or careless handling of the machine, or working in a con¿ ned area.
Suitable PPE must be worn when using this equipment i.e. Safety Goggles, Gloves, Ear Defenders, Dust Mask and Steel Toe capped
footwear. Wear clothing suitable for the work you are doing. Tie back long hair and remove any jewellery which may catch in the
equipment's moving parts.
Dust
The compaction process can produce dust, which may be hazardous to your health. Always wear a mask that is suited to the type of
dust being produced.
Fuel
Oil and fuel used in this machine may cause the following hazards.
• Poisoning if the fuel or oil vapour is inhaled.
• Allergies if the fuel or oil spills on the skin.
• Fire and explosion if the fuel and oil is handled near smoking or open ¿ res.
• Do not ingest fuel or inhale fuel vapours and avoid contact with your skin. Wash fuel splashes immediately. If you get fuel in your
eyes, irrigate with copious amounts of water and seek medical attention as soon as possible.
Exhaust Fumes
WARNING
Do not operate your RT Rammer indoors or in a con¿ ned space, make sure the work area is adequately ventilated.
This machine is intended for base preperation, driveways, foundations, curbs, and footings. It can
also be used for repair work on streets, highways and/or sidewalks/pavements.
Pre start-up inspection
The following Pre-start-up inspection must be performed before the start of each work session or after every four hours of use, which-
ever is ¿ rst. Please refer to the service section for detailed guidance. If any fault is discovered, the RT must not be used until the fault is
recti¿ ed.
1. Thoroughly inspect the RT for signs of damage.
2. Check hoses, ¿ ller openings, drain plugs and any other areas for signs of leakage. Fix any
leaks before operating.
3. Check the engine oil level and top up as necessary.
3.1 Place the machine on a level surface, and check the oil level in the engine.
3.2 Remove the oil guage, and observe that the oil is up to the rim of the ¿ ller port.
Use proper engine oil with the proper viscosity. SAE 10W-30 recommended)
4. Check the engine fuel level and top up as necessary. Use clean fuel. Use of contaminated
fuel may damage the fuel system.
NOTICE: This machine uses Unleaded Gasoline/Petrol.
CAUTION
NEVER ¿ ll the fuel tank with a mixture of Oil and Gasoline/Petrol.
5. Check that the air ¿ lter is clean. Excessive dust/dirt accumulation within the ¿ lter element will cause erratic engine operation.
Clean the air ¿ lter element when it is contaminated (See Maintenance section).
Health & Safety
The exhaust fumes produced by this equipment are highly toxic and can kill!

Intended Use

Pre-Start Checks
19