Yukon Signal N320RT Manual De Instrucciones página 14

Problem Check
The unit is beyond reliable Wi-Fi range.
No Wi-Fi signal or erratic
signal. There are obstacles between the unit
and the signal receiver (concrete walls
for example).
There are too many Wi-Fi networks
in the area where the device is
located which may cause signal
interference.
The unit is not operating Please restore the original firmware
properly due to firmware version.
update.
21
Corrective action
Place the unit in line-of-sight of the Wi-Fi signal.
To ensure stable Wi-Fi performance, move the
device to an area with few or no Wi-Fi networks.
1) Connect an external power supply or insert
batteries into the device.
2) Hold down simultaneously the IR and ZOOM
buttons.
3) Start the device with a brief press of the ON
button. Display will blink twice.
4) Return to the original firmware is in process
which may take approx. 1 minute. Release the
buttons.
After successful firmware installation display will
blink uniformly.
5) Disconnect the device from the power supply
(remove the batteries or disconnect an external
power supply). The device will not turn off with the
ON button.
6) The device is ready to operate.
NOTES
22