Gear; Clothing; Use - Texas Hobby 500 B Manual De Instrucciones

For further information about the motor, see the attached motor manual.

Gear

The gear has not been equipped with grease when sent from the fabric.
The gear shall be filled with 60 ml grease for every fifth operation hour.

Clothing

When using the machine, wear tight-fitting work clothes,
strong working gloves, hearing protectors and boots with
non-skid soles.

Use

Clean the area of all foreign items before use. Stone, glass, branches, etc. can damage
the tiller. Check that all bolts on the tiller are tightened.
Start:
Place the throttle handle on choker/full throttle.
Follow the guide in the user manual to start.
Stop:
Place the throttle handle on minimum throttle.
Follow the guide in the user manual to stop.
The Hobby 500 cultivator is intended for use in vegetable gardens and flower beds. It can
also be fitted with various accessories for a number of different uses.
Read the motor manual carefully, especially the part about starting and stopping.
When the gear lever on the right side of the handle is pressed down, the rotor blades
begin to turn. To ensure optimal tension of the belt, is it important to press the lever all the
way down, towards the handle. The belt transmits power from the motor to the
transmission.
For best results, cultivate the soil 2-3 times in different directions.
Figure 14
If the tiller has a tendency to dig down, there are several things you can do. The right and
left blade set can be changed. This means that the tiller will use the reverse of the blade to
till, and thus it will not be so easy to dig down. In addition, side guards can be fitted. This
also helps prevent the tiller from digging down.
The depth skid must always be placed in the top notch if this is the case. See also the
section on adjusting the depth skid.
In addition to the speed of the engine, the speed is controlled by the depth skid, which is
placed behind the machine.
12