• Children of less than 3 years should be kept away unless continuously supervised.
• Children aged from 3 years and less than 8 years shall only switch on/off the appliance pro-
vided that it has been placed or installed in its intended normal operating position and they
have been given super¬vision or instruction concerning use of the appliance in a safe way and
understand the hazards involved.
• Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
• This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and un¬derstand
the hazards involved.
• Children should not play with the product.
• Only for internal use
ASSEMBLY
For transport reasons, the wheels are not fi tted and are supplied separately within the packaging.
1. Remove the wheel set from the packaging.
2. Mount the four wheels on the two metal supports. Be sure to put the security screws in the posi-
tion shown in Figure 1. Properly tighten all screws to prevent loosening.
3. Overturn carefully the radiator on a carpet or other soft surface, to avoid damaging the appliance.
4. (Fig. 2) Insert the locking ring into the hole in the base of the wheel. Place the wheel under the
radiator. Once properly seated, place the ring inside the other support hole. Fix the ring against
the support by butterfl y screw.
5. Check that the wheels have been mounted correctly.
6. Put the radiator in vertical position and wait about 15 minutes before connecting the device in the
electrical ductwork, to ensure that all the oil inside has drained into the base.
START-UP AND OPERATION
1. Before connecting the device to the mains, check that the grid voltage coincides with that shown
on the data plate.
2. Turn the thermostat control (Fig. 3 C) clockwise to its maximum position.
3. Select the desired power setting using the two switches with light indicator (Fig. 3 A-B).
SAHARA series models have 3 operating options, with different heating outputs:
II + I
II
I
Heating outputs
HIGHT
MEDIUM
LOW
9 9