Operating Temperatures; Shutting Down The Compressor - Bosch CET8-15W Instrucciones De Funcionamiento

ADjUSTING reGUlATOr
This compressor is provided with an internal reg-
ulator that controls the output pressure of two
female quick connect couplers. Regulated pres-
sure will be equal to or less than tank pressure
depending on user setting.
Regulator (A)
To adjust regulated pressure:
1. Pull regulator knob out.
2. To increase pressure, turn clockwise.
3. To decrease pressure, turn counter clockwise.
. When desired pressure is set, push regulator
knob in to lock pressure.
5. Regulated pressure is displayed as (B).
CONNeCTING AIr SUPPly
Firmly grasp the hose in hand
WARNING
when installing hoses. If hose is
not held firmly or correctly installed hose may whip
and injure personnel in the operating area.
INSTALLING HOSES:
1. Grasp the hose at the quick connect plug and
push the plug into the quick connect body.
Coupler will snap into place.
0
Regulator Pressure
Gauge (B)
Fig. 6
Fig. 7
OPERATION
2. Grasp the hose and pull to ensure coupler is
seated.

OPerATING TeMPerATUreS

Operating temperatures are between 32ºF and
104ºF (0ºC and 40ºC). If operating outside recom-
mended temperatures, unit may have difficulity
starting and will cause additional wear on compo-
nents.
WARNING
air tanks and allow it to cool before making
adjustments, moving the compressor, leaving
the work area, performing maintenance or
storing the compressor.
safety measures reduce the risk of injury.

SHUTTING DOWN THe COMPreSSOr

. Move On/Off switch to the OFF position.
2. Turn regulator until output pressure reads
0 psi.
3. Remove hose and assembly. See disconnecting
air supply below.
4. Drain air from the air tanks by releasing air by
pulling the safety release valve.
5. Once the air tank pressure is under 20 psi., open
the drain valve on the control panel to drain
moisture from the tanks (See draining tanks on
page ).
. Allow the compressor to cool down before
storing.
DISCONNeCTING AIr SUPPly
DISCONNECTING HOSES
. Ensure regulated pressure gauge reads 0 psi
(0 kPa).
Fig. 8
Disconnect the
from the power source, drain
Such precautionary
compressor