Makita DTD134 Manual De Instrucciones página 7

Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
1
2
012009
To install the bit, insert the bit into the sleeve as far as it
will go.
1
2
012063
To remove the bit, pull the sleeve and pull the bit out.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
When it is difficult to insert the bit, pull the sleeve
•
and insert it into the sleeve as for as it will go.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
Hook
1
012014
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
1. Bit
2. Sleeve
1. Bit
2. Sleeve
1. Hook
2. Screw
2
OPERATION
012050
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
Standard bolt
N m
(kgf cm)
120
(1,224)
100
(1,020)
80
(816)
60
(612)
M10
40
(408)
M8
20
(204)
0 1.0
Fastening time (S)
006255
High tensile bolt
N m
(kgf cm)
120
M12
(1,224)
100
(1,020)
80
(816)
60
(612)
M8
40
(408)
20
(204)
0 1.0
Fastening time (S)
006257
7
M14
M12
(M14)
(M12)
(M10)
(M8)
2.0 3.0
(M12)
M10
(M10)
(M8)
2.0 3.0