Chicco YOU & ME Instrucciones De Uso página 25

1. Insert the arms into the two shoulder straps
openings, one at a time (diag. 1).
2. Adjust the length of the shoulder straps,
holding the main adjustment straps. Pull
the straps, ensuring they adhere correctly
to the shoulders (diag. 2). This operation
adjusts the upper rear part of the backrest.
3. Hold both lower buckles with the right
hand, and pull the secondary adjustment
straps with the other hand (diag. 3), ensur-
ing that the backrest adheres correctly to
the bust. Repeat the same operation on
the other side. This operation adjusts the
lower rear part of the backrest.
4. To ensure maximum comfort while carrying
the child, the Ergo System backrest must
be placed in a central position, slightly be-
low the shoulder blades (diag. 4): it should
adhere correctly to the back and lumbar
region of the adult to ensure maximum
comfort.
GROWTH ADJUSTMENT SYSTEM
WARNING: This operation must be carried out
before placing the child in the baby carrier.
The baby carrier has a special growth adjust-
ment system that allows you to adjust the
baby carrier to suit the child's development.
5. Open the two zips, as shown in diag. 5.
6. Hold the height adjustment buckle and pull
the strap, until the baby carrier is adjusted
to the desired size (diag. 6).
7. Close the panel again at the end of the op-
eration (diag. 7).
Information for parents: Some sizes/heights
are indicated near the height adjustment
buckle of the baby carrier, in order to make the
adjustment operations easier.
WARNING: Before placing the child in the
baby carrier, ensure that the adjustment buck-
le is fastened correctly into position.
HOW TO FIT THE BABY CARRIER TO THE
SHOULDER STRAPS
8. To fi t the baby carrier to the shoulder straps,
it is necessary to hold the lower buckles of
the shoulder straps and fasten them to the
corresponding lower open/close buckles of
the baby carrier (diag. 8).
WARNING: Exercise pressure until a "clack" is
heard, indicating that the buckle is fastened
correctly into position.
9. Adjust the length of the shoulder straps,
one at a time, adjusting the secondary
adjustment straps, until the baby carrier is
closely positioned against the upper part of
the adult's thorax (diag. 9). This operation
is necessary to ensure maximum comfort
for the adult and the child and to distrib-
ute the weight in the best way, so ensuring
maximum safety for the child.
ADJUSTMENT SYSTEM FOR THE PARENT'S
BODY
WARNING: This operation must be carried out
before placing the child into the baby carrier.
The baby carrier has an adjustment system
that ensures maximum comfort and the best
adjustment to any type of body size.
10. Hold the two ends of the upper open/clo-
se buckle with the fi ngertips and exercise a
slight pressure on the sides to unfasten the
buckle (diag. 10).
11. Raise the tab to release it from its position
of use (diag. 11).
12. Slide the buckle set into the appropriate
guide, until the desired height is reached
(diag. 12).
13. Lower the buckle, and exercise a slight
pressure on the side of the tabs to fasten
the buckle again in its safety position (diag.
13).
Both shoulder straps must be adjusted exactly
at the same height.
14. To carry the child in a correct and safe posi-
tion, the adjustment buckle must be posi-
tioned as shown in diagram 14.
WARNING: Always check that the buckle is
fastened correctly before carrying out any
other operations. It will be impossible to fi t
the baby carrier to the shoulder straps if this
adjustment operation has not been carried out
correctly and the tabs are not fi tted correctly
into position.
HOW TO PLACE BABY INSIDE THE BABY
CARRIER
It is recommended that you place the child in
the baby carrier while sitting.
25