Assembly; Cup Holder - BABYTREND TS53 Serie Manual De Instrucciones

ASSEMBLY

ATTATCHING THE SEAT
ONLY
• approved Snap Tech products can be
TM
used on the frame.
4) • Make sure the seat fabric is properly
attached to the seat support bar. If the
seat fabric is unzipped, wrap the seat
fabric around the seat support bar (Fig.
4a) and zip the fabric closed.
• Attach the seat by lining up the seat
anchors on the side of the seat with the
anchors on the stroller frame and pushing
them together until they click securely
(Fig. 4b). The seat can face in either
direction, frontward or backward.
NOTE: To remove the seat see step 16.
TO ADJUST SEAT
5) • The seat can be adjusted into upright,
reclined and carriage position. Pull the
recline button on the rear of the seat and
rotate the seat into the desired position
(Fig. 5a).
• Upright and Reclined Position: There
are two seat adjusters on the back of
the stroller seat pad: an upper and lower
adjuster. Pull tight the upper adjuster
for upright seating position. Loosen the
adjuster for a desired recline position.
Fasten the lower buckle for upright
position and pull the excess strap through
the plastic ring and secure in place with
hook and loop (Fig. 5b).
• Carriage Position: Make sure the upper
adjuster is fully loosened and the lower
buckle is unbuckled to fully extend the
seat surround (Fig. 5b).
7
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
REMOVABLE CANOPY
6) • To attach the Removable Canopy:
Fig. 4a
Fig. 4b

CUP HOLDER

Fig. 5a
7) • To attach cup holder: slide the clip on the
Hook
and
Loop
Fig. 5b
Snap the Canopy clips on the inside
of the Toddler Seat Tubes. Tighten the
hook and loop strap around the Canopy
hinge (Fig. 6a).
• To open the canopy: push forward on
the front edge of the canopy while holding
the rear of canopy in place (Fig. 6b).
• To fold the canopy: pull backwards on
the front edge (Fig. 6b).
• To use the extended canopy: unzip
the middle of the canopy and pull the
canopy forward (Fig. 6c).
WARNING:
To avoid
burns, never put hot liquids
in cup holder. Avoid possible
tipping, do not place more
than 1 lb. (0.45kg) in cup
holder.
cupholder over Cup Holder tabs on the
Handle Bar. Push untill firmly in place
(Fig. 7).
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 6a
Fig. 6b
Fig. 6c
Fig. 7
8