Overview Of The Components - AEG MC 4461 BT Instrucciones De Servicio

Overview of the Components

1 CD compartment
2 Tab for opening the CD compartment
3 Display
4 button (next title / search run forward)
5 button (decrease volume / alarm time 1)
6 button (increase volume / alarm time 2)
7 button (album / equalizer function)
8 Control for tuning the radio stations
9 MODE/DISPLAY/CLK SET button (setting of mode /
display / time)
10 USB connection
11 / FUNCTION button (on / operational readiness /
selecting source)
12 / button (play / pause / stop)
13 button (previous track / search run backward)
14 IR sensor for the remote control
15 Control lamp (Bluetooth)
Back (not shown)
Speaker connections (SPEAKERS R/L)
Mains cable
FM dipole antenna
AUX jack
PHONES headphone jack
Remote Control
1 FUNC. button (select source)
2 button (play / pause)
3 / buttons
4 ALBUM− / ALBUM+ buttons
5 PROG button
6 MODE/CLK button (set mode / time)
7 V−/AL1 / V+/AL2 buttons (volume / alarm time)
8 button (stop)
9 button (on / operational readiness)
Start-up of the Device / Introduction
• Select a suitable location for the device and the loud-
speakers. An even, skid-resistant surface on which you can
easily operate the device would be suitable.
• Ensure that the device is adequately ventilated!
• Connect the speakers on the back to the terminals
"SPEAKERS R and L".
• Sensitive areas, such as the display may be protected with
foil. Remove these foils.
Transport Protection CD Compartment
1. Open the CD compartment (1) by pulling the lid upward
by the tab (2).
2. If present, remove the transport protection from the CD
player before use.
MC4461BT_IM_new2 ab PO7108
Power Supply
• Pay attention to the mains voltage! The type plate lists
the correct voltage for your device.
• Insert the mains plug into a properly installed power
socket.
• If the device is not used for a longer period of time, the
mains plug must be disconnected from the socket.
Remote Control
NOTE:
The lithium cell in the battery compartment of the remote
control was secured with foil for transport. This extends the
battery life. Remove this foil before initial use to operate
the remote control.
For wireless operation from a distance of up to 5 meters.
During operation, please ensure a clear line of view between
the remote control and the sensor (14) on the device. If
this range should diminish, the battery must be replaced.
Replace the battery as follows:
1. Open the battery compartment.
2. Replace the cell with a battery of the same type (CR 2025).
Please observe the correct polarity.
3. Close the battery compartment.
WARNING:
• Do not expose the batteries to intense heat such as
sunlight, fire or similar. There is a risk of explosion!
• Keep batteries away from children! They are not a toy.
• Do not open batteries with force.
• Avoid contact with metallic objects (rings, nails, screws,
etc.). There is a risk of short circuit!
• Batteries may heat up considerably through a short
circuit or may even ignite. It could result in burns.
• The battery terminals should be covered with adhesive
tape during transport for your safety.
• Batteries can leak out and can lose battery acid. If the
device is not used for a longer period of time, remove
the battery from the remote control.
• If a battery does leak out, do not rub the liquid into your
eyes or the mucous membranes. In case of contact, wash
your hands, rinse your eyes with clear water, and if the
symptoms persist, consult a doctor.
CAUTION:
• Batteries can leak out and can lose battery acid. If the
device is not used for a longer period of time, remove
the battery from the remote control.
• Batteries do not belong in the household waste. Please
dispose of spent batteries at authorized collection
points or at the dealer.
English
45
29.12.16