Menu Function; Stand-Alone Mode; Master/Slave Mode; Dmx Mode - Velleman HQ-Power EXPLIO III - CABEZA MÓVIL - 12 X LED RGBW DE 10W Manual Del Usuario

To change a setting
1. Press <MENU> until the menu option appears.
2. Press <ENTER> to enter the menu.
3. Press <UP> or <DOWN> to change the setting.
4. Press <ENTER> to confirm (or press <MENU> to cancel).
The menu contains the following items:
Menu item
DMX Address Set
Channel Set
Show Mode
Slave Set
Black out
Sound Mode
Sound Sense
Pan Inverse
Tilt Inverse
Black Light
White Balance
Fixture Test
Defaults
Temp.
Fixture Reset
7.2

Stand-Alone Mode

In stand-alone mode, the LEDs of the device will synchronize with the music through the built-in
microphone.
To set the device to stand-alone mode:
1. Connect nothing to the DMX input of the device.
2. Press <MENU> until Sound Mode is displayed and press <ENTER>.
3. Press <UP> or <DOWN> to select the desired setting:
On: the device runs slowly when there is no sound.
o
Off: the device stops when there is no sound.
o
4. Press <ENTER> to confirm.
5. If necessary, set the sensitivity of the internal microphone with the sensitivity knob.
7.3

Master/Slave Mode

The master/slave mode allows connecting several devices to a single master device. All slave devices will
then work synchronously with the master device.
You need to set one device to master mode and all other devices to slave mode.
1. Connect all devices in series with DMX cables.
2. The first unit in the chain functions as the master device. Set up the unit as described above.
3. On each slave device, press <MENU> until < Slave Set > is displayed and press <ENTER>.
4. Use <UP> and <DOWN> to select the appropriate mode and press <ENTER>.
7.4

DMX Mode

This mode allows you to control the device by any universal DMX controller.

All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.

When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
V. 01 – 18/02/2013
VDPL1210MHRGBW

Menu function

Sets the DMX address
Sets the channel
Sets the program type
Sets the slave mode (slave1 = exact copy of master, slave2 = offset
pan and tilt)
Determines whether the device starts playing an auto program when
powered up or remains in the default position
Turns sound activation on or off
Sets the sound sensitivity
Turns reverse pan on or off
Turns reverse tilt on or off
Turns the black light on or off
Sets white balance.
Tests the fixture. Press <ENTER> to stop the test.
Resets default settings
Shows the fixture‟s temperature.
Resets the fixture to its original position.
6 ©Velleman nv