Tools Required - Waeco PerfectView CRT245 Instrucciones De Montaje Y De Uso

RV-245.book Seite 38 Freitag, 25. November 2005 4:25 16

Tools required

When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They re not laid in sharp edged ducts without protection (see fig. 1.E, page 3).
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insulating tape,
for example to existing cables.
The camera is watertight, however, you should observe the following instructions when
handling the camera:
Do not subject the camera to a direct stream from a high-pressure cleaning device.
Do not open the device, as this impairs the sealing and the function of the camera.
Do not pull at the cables, as this impairs the sealing and the function of the camera.
The camera is not suitable for submerged operation.
3 Tools required
For installation and assembly
No. in fig. 2, page 4 Description
A
B
C
D
E
F
G
38
Measuring ruler
Centre punch
Hammer
Drill bits
Drill
Screwdriver
Spanner
PerfectView CRT245