Troubleshooting; Troubleshooting Chainsaw Or Battery - Stihl MSA 160 T Manual De Instrucciones

Ocultar thumbs Ver también para MSA 160 T:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 107

18 Troubleshooting

18 Troubleshooting

18.1 Troubleshooting Chainsaw or Battery

Condition
LEDs on Battery
Saw does not start
1 LED flashes
when switched on.
green
1 LED glows red. Battery too hot or too cold. ► Engage the chain brake and remove the battery.
3 LEDs flash red. Malfunction in saw.
3 LEDs glow red
4 LEDs flash red. There is a malfunction in
Saw cuts out during
3 LEDs glow red
operation
0458-706-9921-A
Cause
Battery has low charge.
Chainsaw is too hot.
the battery.
No electrical contact
between the chainsaw and
battery.
Saw or battery damp
Chainsaw is too hot.
Remedy
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 101, 300, 500
chargers.
► Allow battery to cool down / warm up.
► Engage the chain brake and remove the battery.
► Clean contacts in battery compartment.
► Fit the battery.
► Disengage the chain brake.
► Switch on the saw.
► If 3 LEDs continue to flash red: Do not use your
chainsaw and contact your STIHL servicing dealer
for assistance.
► Engage the chain brake and remove the battery.
► Allow chainsaw to cool down
► Engage the chain brake, remove and refit the
battery.
► Disengage the chain brake.
► Switch on the saw.
► If 4 LEDs continue to flash red: Do not use the
battery and contact your STIHL dealer for
assistance.
► Engage the chain brake, remove and refit the
battery.
► Allow saw or battery to dry
► Remove the battery.
► Allow chainsaw to cool down
English
61
Tabla de contenido
loading

Tabla de contenido