Stand-Alone Mode; Master/Slave Mode - HQ-Power VDPL1210MHRGBW Manual Del Usuario

3. Press <UP> or <DOWN> to change the setting.
4.
Press <ENTER> to confirm (or press <MENU> to cancel).
The menu contains the following items:
Menu item
DMX Address
Channel Mode
Show Mode
Slave Mode
Black out
Sound State
Sound Sense
Pan Inverse
Tilt Inverse
Back Light
White Balance
Manual Test
Auto Test
Temp.
Fixture Time
PRO defaults
Reset
7.2

Stand-Alone Mode

In stand-alone mode, the LEDs of the device will synchronize with the music through the built-in
microphone.
To set the device to stand-alone mode:
1. Connect nothing to the DMX input of the device.
2. Press <MENU> until <SOUND MODE> is displayed and press <ENTER>.
3. Press <UP> or <DOWN> to select the desired setting:
100: maximum sound sensitivity.
o
0: no sound sensitivity.
o
4.
Press <ENTER> to confirm.
5. If necessary, set the sensitivity of the internal microphone with the menu option Sound Sense.
7.3

Master/Slave Mode

The master/slave mode allows connecting several devices to a single master device. All slave devices will
then work synchronously with the master device.
You need to set one device to master mode and all other devices to slave mode.
V. 02 – 26/09/2013
VDPL1210MHRGBW
Menu function
Sets the DMX address
Sets the channel (9, 14, 16, or 28 channels)
Sets the built-in program type
Sets the slave mode
Slave1 = exact copy of master
Slave2 = offset pan and tilt)
Set this option to Yes to stop a built-in program.
When set to Yes, the device will not play any built-in program when
powered up.
When set to No, the device will automatically start playing the last
built-in program..
Turns sound activation on or off
Sets the sound sensitivity
100: maximum sound sensitivity.
0: no sound sensitivity
Turns reverse pan on or off
Turns reverse tilt on or off
Turns the display light on or off.
On: display remains on.
Off: display turns off after 1 minute.
Sets RGB adjustement
Manually tests the fixture's Pan, Tilt, colours, Dimmer and Strobe.
Press <ENTER> to stop the test.
Press ENTER to access the menu.
Use UP or DOWN to select the item you want to test and press
ENTER.
Use UP or DOWN to set the item's value and press ENTER.
@@@
Performs a series of automatic tests.
Press <ENTER> to stop the test.
Shows the fixture's temperature.
Displays the number of working hours
Resets all the fixture's settings to factory settings
Resets the fixture to its original position.
6 ©Velleman nv