Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Setting the unit
What's what
Right side
Front side
3
2
Back side
To adjust the switch, use a flathead screwdri-
ver if needed.
1 GAIN (gain) control
If output remains low, even when the car
stereo volume is turned up, turn controls to
lower level. If distortion occurs when the car
stereo volume is turned up, turn these con-
trols to higher level.
! For use with an RCA equipped car stereo
(standard output of 500 mV), set to the
NORMAL position. For use with an RCA
equipped Pioneer car stereo, with maxi-
mum output of 4 V or more, adjust level
to match that of the car stereo output.
! If you hear too much noise when using
the speaker input terminals, turn the
gain control to higher level.
2 Terminal cover
3 Power indicator
1
4 INPUT (input) switch
2
4
! If using only one input plug, set the gain
controls for speaker outputs A and B to
the same position.
Remove the cover before connecting the
amplifier. For details, refer to Before connect-
ing the amplifier on page 5.
The power indicator lights up to indicate
power ON.
Select 2CH for two-channel input and 1CH
for one–channel input.
Section
01
3
En
Tabla de contenido
