Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Be sure to allow no more than six inches of cable between the
machine and drain opening. Too much slack in the cable can
cause it to tangle and kink.
6. Repeat procedure until you have worked through the
stoppage.
7. Reverse the procedure to pull the cable out of the line.
WARNING: DO NOT USE REVERSE TO PULL CABLE OUT
OF THE DRAIN. ALWAYS RUN YOUR MACHINE IN FORWARD,
WHETHER YOU ARE FEEDING THE CABLE INTO THE LINE OR
PULLING IT OUT. USE REVERSE ONLY TO RELEASE CABLE IF IT
SHOULD BECOME CAUGHT IN THE LINE.
TIP: It is often useful to have a small flow
of water in the line to remove debris from
cuts while the machine is in operation and
thereafter.
TO CHANGE CABLE CARTRIDGES
1. Remove the cutter and screw from the cable, if one is
attached.
2. Loosen the three screws that hold the front and back of
container together.
3. Pull the container off the front of machine.
4. Remove the cartridge. Press replacement cartridge firmly into
back of container. Make sure to line up grooves in the cartridge
with slots in the container back.
5. Slide cable through the front of the container. Be sure the
grip shield is in the forward position. Position container front
so that the screws and slots in the container back are aligned.
6. Tighten screws firmly, making sure they are centred in the
slots, and tightened so that the heads of the screws are flush
with the container.
CABLE APPLICATIONS
Cable Size
1/4"
5/16"
3/8"
The 1/4" and 5/16" diameter cables with plug heads can be spun through most strainer crossbars and work well in lines blocked by soft stoppages such as hair, soap,
fats, etc.
BEFORE SERVICING.
To keep your machine operating smoothly, it is essential that
all bearings and cables be lubricated. Oiling moving parts is
particularly important where machine comes into contact with
sand, grit and other abrasive material.
To get maximum service from your cables, be sure they are
well oiled. Some users periodically pour oil directly into the
container, Then as the container turns, the cables get complete
lubrication, our snake oil is ideal for this purpose since it not
only lubricates the cables; it disinfects and deodorizes them as
well.
TO CLEAN OR REPLACE GRIPPERS
If your Sink Machine is not gripping the cable properly, the
cable grippers may need to be cleaned or replaced.
1. Loosen 3/8" set screws in the front collar.
2. Remove the front collar and slide off the grip shield.
3. Remove screws holding the cable grippers.
4. Clean or replace cable grippers.
5. Re-grease grippers and reassemble.
TO REMOVE MOTOR
1. Pull the cable out of the container.
2. Loosen the three screws that hold the front and back of
container together.
3. Pull the container off the front of machine.
4. Loose set screws in bevelled collar and remove both the collar
and the felt washer.
5. Slide a flat head screw driver into the Hub Spindle and
unscrew the Left Hand locking screw from the drive shaft by
turning it clockwise.
6. Unscrew the Hub Spindle from the Right Hand Drive Shaft by
rotating the container back counter-clockwise.
Note: The Hub Spindle, Hub, and Container Back remain as one
unit, Thrust Bearing will come free.
7. Reverse these instructions when re-assembling.
Pipe Size
1 1/4" - 2"
1 1/2" - 2"
2" - 3"
MAINTENANCE
WARNING: DISCONNECT MACHINE FROM POWER SOURCE
Typical applications
Small lines, tubs, and shower drains
Sinks, basins, and small drains
Stacks, toilets, small drains (Not roots)
E N G L I S H •
U s er 's man ual
9
Tabla de contenido
