Cleaning; Troubleshooting - Britax BOULEVARD CLICKTIGHT Guia Del Usuario

BRITAX Child Safety, Inc.
7. Route the harness straps
through the seat to the
back. Ensure that the
harness straps pass over
the tube.
8. Nest the end of the left
harness strap into the
right.
9. Slide the harness straps
completely onto the yoke.
Ensure that the adjuster
and harness straps are
not twisted and that
the ends of the harness
straps are securely
attached to the yoke.

Cleaning

Shell • SPONGE CLEAN the
shell using warm water
and mild soap.
• TOWEL DRY.
Cover • HAND WASH the
cover using cold water
and mild soap.
• LINE DRY to prevent
the cover from
shrinking.
Harness • SPONGE CLEAN the
harness using warm
water and mild soap.
• TOWEL DRY.
Harness • THOROUGHLY RINSE
Buckle the buckle using warm
water.
• TEST THE BUCKLE
by fastening and
unfastening until a
click is heard after
inserting each buckle
tongue. If clicks are
not heard, repeat the
cleaning procedure.
• TOWEL DRY
42
TUBE
DO NOT
• Use abrasive
cleaners.
DO NOT
• Bleach
• Machine wash
• Machine dry
• Iron
DO NOT
• Disassemble the
harness
• Bleach
• Machine wash
• Machine dry
• Iron
DO NOT
• Soak
• Lubricate
• Use solvents
• Use soap or
household
detergents
BOULEVARD CLICKTIGHT User Guide

Troubleshooting

Problem
The There may be debris or other objects
CLICKTIGHT
interfering with the mechanism.
will not close
Ensure the seat area is clear of any
with a click to
obstructions and try closing the
signal that
CLICKTIGHT again.
it is secure�
There may be too much tension in
the belt/strap. Do not overtighten
the belt/strap before closing the
CLICKTIGHT. Only remove slack.
The logo on the Press down again on the
CLICKTIGHT dial CLICKTIGHT to the left and right of
will not return the bezel to ensure the CLICKTIGHT
to a horizontal pins have fully engaged.
position�
The harness There may be debris in the
adjuster button
mechanism. Clean the mechanism,
will not operate�
then try using the button again.
The harness Check the seating position where
cannot be
the child seat is installed. The vehicle
adjusted to its
head restraint may obstruct the path
full height�
of the child seat harness height
adjuster. Remove or raise the vehicle
head restraint and try adjusting the
harness height again.
The harness Harness length can be extended if
length is too
necessary for children over the age
short�
of 2. For more information, contact
BRITAX Consumer Services at 1-888-
427-4829 or 1-704-409-1699.
The harness is The harness may be at maximum or
hard to adjust�
minimum height, the harness may
be too tight to adjust, or the child's
weight may be pressing against the
head pad. Check for and correct all
of the above where necessary and
try adjusting the harness again.
The adjuster Pull the harness adjuster strap up and
strap is fraying
away from the child seat to tighten.
at the sides�
Do not pull sideways. Doing so may
cause the harness adjuster strap to
fray at the sides. See page 21.
The buckle will There may be debris in the buckle
not fasten with
mechanism. Clean the buckle (see
a click after
page 42), then try fastening the
each tongue is
buckle again.
inserted�
Please contact BRITAX Consumer Services at 1-888-427-
4829 or 1-704-409-1699 if you have an issue not listed
here.
Possible Solution
43