Cleaning And Care; Storage - Carrera 622 Manual De Instrucciones

To remove the variable attachment comb, press the cutting length
● ●
adjustment button, fully extend the variable attachment comb and
pull it off.
Clipping with the variable attachment combs
Using the variable attachment combs, you can vary the cutting
● ●
lengths in 6 steps each. The cutting lengths of the variable attach-
ment comb 22 are 4/7/10/13/16/19 mm; those of the variable
attachment comb 23 are 21 / 24 / 27 / 30 / 33 / 36 mm.
NOTE: The cutting lengths can only be achieved
when you position the appliance with the surface
of the comb (see fig.).
The fine adjustment must be set to 0.8mm –
slide switch in upper position.
Clipping without the variable attachment comb
If you want to cut your hair to a very short length without using the
● ●
variable attachment comb, the cutting length can be set between
0.8 and 2 mm using the slide switch for the fine adjustment.
NOTE: The cutting lengths can only be achieved
when you position the appliance with the short
front cutting surface – relatively steep (see fig.).
Thinning your hair using the thinning attachment
Use the comb attachment with thinning function
● ●
NOTE: For thinning your hair, leave the 2mm fine adjustment unchanged.
Move the hair clipper with the cutting surface towards the hair.
● ●
The thinning comb must not be placed on the scalp.
● ●
32 GB

08. CLEANING AND CARE

NOTE: Clean and oil the device after every use.
●
●
Cleaning and oiling the shaving unit

09. STORAGE

23 to thin your hair.
●
DANGER!
Remove the wall power supply from the socket before cleaning
the device.
WARNING!
Always switch off the device before cleaning it.
CAUTION!
Do not use any harsh or abrasive cleaning agents.
Remove the variable attachment comb. Rinse the variable attachment
●
comb with water and let it dry before reattaching it to the device.
Wipe down the housing of the device with a damp cloth.
●
1. Remove the shaving unit from the appliance by pressing it with the
thumb towards the rear (see fig. C).
2. Use the provided brush to remove the hair remnants from the
shaving unit.
3. The shaving unit can be cleaned under running water. Allow it to
dry well before reattaching it.
4. Apply a few drops of oil onto the cutting edge of the shaving unit.
Use a soft cloth to wipe off the excess oil, if necessary. Only use
acid-free oil such as sewing machine oil.
5. Carefully press the shaving unit from the rear onto the device until
it locks into place.
DANGER! Remove the mains plug from the device. Do not wrap
the cable around the device (Danger! Risk of cable break!).
Keep the device in a dry, dust-free room.
●
GB 33