Operation; Cleaning And Care - Carrera 623 Manual De Instrucciones

Deactivating the travel lock
1. Press and hold the on/off switch 3 for more than 5 seconds; the
travel lock is deactivated and the beard trimmer switched on.
2. The travel lock will also be deactivated by connecting the beard
trimmer to the mains.

07. OPERATION

Regardless of the state of charge of the batteries, mains operation of the
appliance is always possible using the provided mains adapter only.
1. For mains operation, connect the USB plug 8 to the USB female
connector 7 and the 5V plug 10 to the appliance.
2. Connect the mains adapter to an easily accessible wall socket.
3. Use the on/off switch 3 to switch on the appliance.
4. Press the on/off switch 3 to switch off the appliance.
Using the variable attachment comb
WARNING! Switch off the appliance before attaching the vari-
able attachment comb.
To attach the variable attachment comb, carefully push the locking
● ●
mechanism of the variable attachment comb 5 into the central
guide groove of the appliance; at the same time, press the cutting
length adjustment button on the back of the comb attachment and
set the desired cutting length.
To remove the variable attachment comb, press the cutting length
● ●
adjustment button, fully extend the variable attachment comb and
pull it off.
Trimming with the variable attachment comb
The variable attachment comb can be used to set the cutting length
● ●
to 6 different levels. With 0.8mm fine adjustment, the cutting lengths
are è 4 / 6 / 8 / 10 / 12 / 14 mm.
28 GB
NOTE: The cutting lengths can only be achieved
when you position the appliance with the surface
of the comb (see fig.). The fine adjustment must
be set to 0.8mm.
Trimming without variable attachment comb
If you want to trim your beard to a very short length without us-
● ●
ing the variable attachment comb, the cutting length can be set
between 0.8 and 2mm using the slide switch for the fine adjustment.
The selected cutting length is shown on the display.
NOTE: The cutting lengths can only be achieved
when you position the appliance with the short
front cutting surface – relatively steep (see fig.).

08. CLEANING AND CARE

DANGER!
Remove the mains adapter from the socket before cleaning the
appliance.
WARNING!
Always switch off the appliance before cleaning it.
CAUTION!
Do not use any harsh or abrasive cleaning agents.
NOTE: Clean and oil the appliance after every use.
GB 29