Features And Controls - Briggs & Stratton Q6500 Manual Del Operador

Compare the illustrations with your generator to familiarize yourself with the locations of various
controls and product warnings.
120/240 Volt AC, 30 Amp
Locking Receptacle
QPT Switch
Power Use
LED's
Overload
Reset
Low Oil
Indicator 120 Volt AC, 20 Amp
GFCI Duplex Receptacles
120 Volt AC, 20 Amp, GFCI Duplex Receptacles — Used
to supply 120 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads.
120/240 Volt AC, 30 Amp Locking Receptacle — Used to
supply 120 / 240 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads.
Low Oil Indicator — This unit is equipped with a low oil
protection device. Oil must be at proper level for engine
to run. If the engine oil drops below a preset level, an oil
switch will stop the engine. Check oil level with dipstick.
Overload Reset — If the generator was overloaded, press
the OVERLOAD RESET button to continue in normal
operating mode.
USB Ports
Main Breaker

Features and Controls

Power Use LED's — Measures the output wattage
(generator load) of all the generator receptacles and
displays the percentage of total generator load.
QPT (QUIET POWER TECHNOLOGY) Switch — Use this
switch to turn the QPT switch on (I) and off (0).
Rocker Switch Circuit Breaker — The receptacles are
provided with a 2 pole rocker switch circuit breaker to
protect the generator against electrical overload.
USB Ports — Use ports to recharge most USB powered
devices.
202997
EN5