Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING :
•
The smoke machine must be placed at least 100 cm away from inflammable materials such as curtains, books, etc.
Make sure that the housing cannot be touched by accident.
For indoor use only.
•
•
During installation, nobody should stand beneath the mounting area.
Prior to the first use, have the unit checked by a qualified person.
•
•
The unit contains voltage carrying parts. DO NOT open the smoke machine
Never plug or unplug the unit with wet hands.
•
•
If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet. It
•
needs to be repaired by a qualified technician.
Only connect this unit to an earthed mains outlet of 220-240Vac 50/60Hz.
•
•
Always unplug the unit during a thunderstorm or when it is not in use.
If the unit has not been used for a longer period of time, condensation can occur inside the housing.
•
•
Please let the unit reach room temperature prior to use.
When you unplug the unit from the mains always pull the plug, never the lead.
•
•
In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a steel
cable, etc. which has to be fastened separately from the mounting bracket.
•
The supplied bracket is the main fixing and must be used to solidly mount the light effect.
In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings must
•
be fulfilled.
Keep out of the reach of children.
•
•
DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
SAFETY :
•
Plug the smoke machine only in an earthed mains outlet or extension cord! ATTENTION: the power cord can only
be replaced by an original replacement.
Be careful when filling the fluid tank. First of all, unplug the mains lead! Then unscrew the cap on the tank and fill
•
it by means of a funnel.
Only use the original smoke fluid which is environmental friendly and, if used correctly, leaves no residues.
•
•
Do not obstruct the openings on top of the case to guarantee good ventilation. The heating element of the
smoke machine generates heat which needs to be removed. Don't put any objects on the smoke machine.
LASER RADIATION !
Do not stare into beam.
Class 2 laser product according to EN 60825-1: 2014
P<1mW λ=662nm red / 532nm green
IMPORTANT
The laser is sensitive to low temperatures. Please operate the laser at a room temperature of at least 18°C. If the
laser is cold, let it heat up for a while otherwise it might not work.
INSTALLATION & USE :
Unpack the fog machine. Do not connect yet the net cable. Connect the lead of the manual control with the 3-pin
©Copyright LOTRONIC 2016
GB
LSM500LAS
2
Tabla de contenido
