Installation; Installing The Glass Cleaner Pouch; Assembly Of The Pad; Extension Poles - unGer Stingray Manual Para El Usuario

3.0 Installation

3.1 Installing the Glass Cleaner Pouch

• Open the compartment on handheld unit by sliding the black button back and
remove the lid (picture 1).
• Take a new pouch out of the box and unscrew the protective cap.
• Be careful not to squeeze or apply too much pressure to the pouch as contents can
spray once the safety cap is removed.
• Push the pouch onto the connector at the top of the compartment. You can rotate the
connection stem up to have better access (picture 2). Always change the pouch with
the cleaning head facing up.
• Push the pouch as far as possible onto the connection stem to prevent leakage
(picture 3).
• Push the pouch and pin down so that it fits into the compartment.
• Replace the lid and confirm that the black button is locked into place (picture 4).
• Attention: When the pouch is removed, prevent the liquid from leaking by replacing
the protective cap. Clean and dry any spills with a clean cloth.

3.2 Assembly of the Pad

• The system is equipped with a triangular shaped microfiber pad.
• The pad provides maximum cleaning power in combination with the Stingray
Glass Cleaner.
• Put the microfiber pad onto the padholder. Fix it in place with the elastic bands
in each corner.
• When the pad is dirty, take it off and wash it. Please see care label on pad.
• The area that can be cleaned with one pad will vary depending on the condition
of the surface being cleaned.

3.3 Extension Poles

• The handheld unit can be used as a hand tool for easy to reach surfaces (picture 5).
• The handheld unit can be extended to reach higher or hard to reach surfaces using
the available short (1.5'/.5m) or long (3.5'/1.1m) extension poles (see page 4).
• The system is designed to use a maximum of three long and one short extension
poles. Never exceed maximum recommended length. Unger is not liable for any
damages or injuries resulting from the failure to follow these instructions.
• When adding extension poles, be sure locking pins are locked into
corresponding pin holes (picture 6).
• To unlock, press the locking pin and separate the extension poles (picture 7).
1
2
3
4
®
5
6
7
5