Adjust Leveling Legs - Sears Kenmore Elite 66495223710 Instrucciones De Instalación

2. Determine which mounting method to use: floor or wall.
If you have a stone or masonry floor, you can use the
wall-mounting method. If you are installing the range in
a mobile home, you must secure the range to the floor.
This anti-tip bracket and screws can be used with wood
or metal studs.
3. Determine and mark centerline of the cutout space. The
mounting bracket can be installed on either the left-hand
or right-hand side of the cutout. Position mounting bracket
against the wall in the cutout so that the V-notch of the
bracket is 12 / " (31.8 cm) from centerline as shown.
1
2
Centerline
A. 12
B. Bracket V-notch
4. Drill two 1 / " (3 mm) holes that correspond to the bracket
8
holes of the determined mounting method. See the
following illustrations.
Floor Mounting
Rear position
Wall Mounting
5. Using the two #10 x 1 5 /
provided, mount anti-tip bracket to the wall or floor.
6. Move range close enough to opening to allow for final
electrical connections. Remove shipping base, cardboard,
or hardboard from under range.
7. Move range into its final location, making sure rear leveling
leg slides into anti-tip bracket.
B
A
1 / " (31.8 cm)
2
Front position
Diagonal (2 options)
" (4.1 cm) Phillips-head screws
8
8. Move range forward onto shipping base, cardboard,
or hardboard to continue installing the range, using
the following installation instructions.

Adjust Leveling Legs

1. If range height adjustment is necessary, use a wrench
or pliers to loosen the 4 leveling legs.
This may be done with the range on its back or with the
range supported on 2 legs after the range has been placed
back to a standing position.
NOTE: To place range back up into a standing position, put
a sheet of cardboard or hardboard in front of range. Using
2 or more people, stand range back up onto the cardboard
or hardboard.
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
2. Measure the distance from the top of the counter to
the floor.
3. Measure the distance from the top of the cooktop to the
bottom of the leveling legs. This distance should be the
same. If it is not, adjust the leveling legs to the correct
height. The leveling legs can be loosened to add up to
a maximum of 1" (2.5 cm). A minimum of
is needed to engage the anti-tip bracket.
NOTE: If height adjustment is made when range is standing,
tilt the range back to adjust the front legs, and then tilt
forward to adjust the rear legs.
4. When the range is at the correct height, check that there
is adequate clearance under the range for the anti-tip
bracket. Before sliding range into its final location, check
that the anti-tip bracket will slide under the range and onto
the rear leveling leg prior to anti-tip bracket installation.
NOTE: If a Trim Kit will be used, the top of the cooktop
should be higher than the counter. See the Installation
Instructions included with the Trim Kit for the correct height.
/ " (5 mm)
3
16
7