Cafe CTS90DP4MW2 Manual De Instrucciones página 4

2 E
SECURING UPPER MICROWAVE/ADVANTIUM OVEN
TO CABINET
For double oven with microwave or Advantium upper ovens. Secure a wooden cleat to side of
cabinet so that the upper oven can be secured to the cleat with provided screws
27" Cabinet requirements
• No shims (or cleats) required when cabinet is in
minimum width condition.
• If cabinet is at maximum width condition, add wood
shims to bring cabinet to minimum condition.
30" Cabinet requirements
• No shims (or cleats) required when cabinet is in
minimum width condition.
• If cabinet is at maximum width condition, fix the wood
cleats as shown in illustration.
2 F
CUTOUT FOR INSTALLATION OVER A
WARMING DRAWER
NOTE: Install the oven only with specific models listed on the label located on top of the oven.
NOTE: Additional clearances between cutouts may be required. Check to be sure the oven
supports above the Warming Drawer location do not obstruct the required interior depth and height.
When installing a Warming Drawer below a single, double, or combination oven, a separate
120V, 60 HZ, properly grounded receptacle must be installed. Refer to installation instructions
packed with the Warming Drawer for specific installation requirements.
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm)
Min.
Continue to Section 3 for Double Wall Oven with Pedestal. Otherwise, continue to Section 4.
1.5"
6.375"
3.0"
Wood Cleats
27.5"
Cleat locations on 30" cabinet
with maximum cutout condition
Per Warming
Drawer
Requirement
3 A
DETERMINING WHEN TO USE THE PEDESTAL
(30" DOUBLE OVENS ONLY)
WHEN TO USE THE PEDESTAL
When replacing an older GE Appliances 30" double wall oven with a new GE Appliances model.
Cutout height = 51-13/16" to 51-15/16". This is our traditional cutout height.
WHEN NOT TO USE THE PEDESTAL
When replacing a 30" double wall oven from another manufacturer (ie. Whirlpool) with a new
GE Appliances 30" double wall oven. Cutout height = 50-1/4". You will need to verify that the
existing cutout matches the 50-1/4" dimension.
If the new GE Appliances 30" double wall oven is being installed into new construction (ie. not a
replacement), then the recommended installation is to use the Pedestal.
3 B PEDESTAL RAIL INSTALLATION
(30" DOUBLE OVENS ONLY)
A. Position the pedestal rails with the top cutout toward the front of the opening and the flanges
on the bottom, pointing toward the center. Locate each rail on the floor or cabinet runner,
slightly inward from the side of the cabinet. Make sure the front of each rail is not protruding
beyond the front of the cabinet opening.
B. Drill pilot holes and attach rails to runner or bottom of cabinet with provided hardware.
Attachment
screws
Flanges toward
center of cutout
Top cutout
toward front