Digital 351 Instrucciones De Montaje página 26

9. Programming
6 Program remote control
7 Delete remote control
8 Impulse operation for door control units
- Command from hand transmitter:
- Command from ext. impulse button:
9 Timer 45 Min.
If activated again before the time expires, the timer is interrupted.
Advice:
The operation mode 5 (awning) is controlled by the relays
K101 and K102. To program this operation mode, only one of
the programming buttons S101 or S102 has to be pressed.
Both channels are programmed at the same time. In case
these channels shall be used for other applications, a new
programming of every single channel has to be carried out.
9.3 Learn the channel
• Turn the rotary switch S104 to position 6.
• Select the channel:
Press the corresponding programming button S101, S102 or S103 until
LED H101 starts to flash.
• Press the button on the hand transmitter that is to switch this channel
within 10 sec.
-> As soon as the transmitter is detected and saved, LED H101 glows up
for approx. 2 sec.
English / Page 26
Short impulse approx. 1 sec.
Impulse for the time of
actuation