Initial Operation - Digital 351 Instrucciones De Montaje

9. Programming
9.1

Initial operation

After switching on the supply voltage, LED H101 glows up
for approx. 1 sec.
Carry out now the functional check:
• Connect the aerial to socket X106.
• Actuate the transmitter.
A signal is sent to the remote control.
LED H101 must flash quickly.
9.2 Program operation mode
Advice:
For every channel a different operation mode can be
programmed.
• Select the operation mode with rotary switch S104.
• Then press the corresponding programming button of the
channel (S101-S103) and hold it, until LED101 goes on.
S104 Function of the switch position
0 Impulse operation (Impulse as long as it is actuated)
1 On / off
2 Timer 1 Min.*
3 Timer 3 Min.*
4 Timer 8 Min.*
*in case it is actuated before this time has elapsed, the timer is started
again.
5 Function 'Awning' (possible for channel 1 and 2 each with S 101 or 102)
- 1. Command relay 1 'on', runtime approx. 2 Min.
- 2. Command both relays 'off'
- 3. Command relay 2 'on', runtime approx. 2 Min.
- 4. Command both relays 'off'
...etc.
English / Page 25
0