Main Functions - Futurelight PFE-1200 Manual Del Usuario

Main functions

- Main menu 0
- DMX address setting, Slave setting
- DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
♦ Select "VALU" by pressing [UP] button.
♦ Press [ENTER], adjust the DMX address by pressing [UP] or [DN].
♦ Press [ENTER] to confirm.
♦ Press [EXIT/DN] in order return to main menu.
- Slave setting
With this function, you can define the device as slave.
♦ Select "SLAV" by pressing [UP] button.
♦ Press [ENTER], the display shows "ON" or "OFF".
♦ Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
♦ Press [ENTER] to confirm.
♦ Press [EXIT/DN] in order to return to the main menu.
- DMX address setting via controller
With this function, you can adjust the desired DMX-address via an external controller.
♦ Select "EBOC" by pressing [UP] button.
♦ Press [ENTER], the display shows "ON" or "OFF".
♦ Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
♦ Press [ENTER] to confirm.
♦ Press [EXIT/DN] in order to return to the main menu.
♦ On the controller, set the DMX-value of channel 1 to "7".
♦ Set the DMX-value of channel 2 to "7"or "8". When set to "7" you can adjust the starting address
between 1 and 255. When set to "8" you can adjust the starting address between 256 and 511.
♦ Set the DMX-value of channel 3 to the desired starting address. If you want to set the starting
address to 57, set channel 1 to "7", channel 2 to "7" and channel 3 to "57". If you want to set the
starting address to 420, set channel 1 to "7", channel 2 to "8" and channel 3 to "164" (256+164=420).
♦ Wait for approx. 20 seconds and the unit will carry out a reset. After that, the new starting address is
set.
♦ Press [ENTER] for 3 seconds to enter the main menu "MODE" (display
flashing)
♦ Press [ENTER] and select "ADDR", "RUN" or "DISP" by pressing [UP]
button.
♦ Press [ENTER] for selecting the desired sub menu.
40/93 51837580_V_1_2.DOC