Tabla de contenido
Idiomas disponibles
Idiomas disponibles
While normal care and regular maintenance will extend the life
of your equipment, prolonged or constant use may eventually
require that service be performed to allow it to continue operat-
ing properly. The troubleshooting
guide below lists the most
common problems, their causes and remedies.
If you prefer, all of these procedures can be performed for you
by a Sears Parts & Repair Center. See the back cover for
important Sears Parts & Repair Center information.
4 ]LWARNING
To avoid serious injury, perform maintenance
on
the rider or mower only when the engine is
stopped and the ground speed levers are set to
PARK.
Always remove the ignition key, disconnect
the
spark plug wire and fasten it away from the plug
before beginning
the maintenance,
to prevent
accidental
starting
of the engine.
Troubleshooting
the Rider
PROBLEM
CAUSE
REMEDY
Engine win
Ground speed controls not set to PARK
Set to PARK.
not turnover
PTO switch in ON position.
Place in OFF position.
or start.
Ground speed levers not in PARK positions.
Move ground speed levers to PARK positions.
Choke not in CLOSED position.
Move choke to CLOSED position.
Key not turned fully to START position.
Turn key fully to START position.
Out of fuel.
Allow engine to cool, then refill the fuel tank.
Engine flooded.
Set choke to OPEN position when cranking engine.
Fuel is old or stale, or water in fuel.
Drain fuel & replace with fresh fuel. Contact Sears
Parts & Repair.
Battery terminals require cleaning.
Clean the battery terminals
Battery discharged or dead.
Recharge or replace.
Spark plug(s) faulty, fouled or incorrectly
Clean and gap or replace.
gapped.
Wiring loose or broken.
Visually check wiring & replace broken or frayed
wires. Tighten loose connections.
Solenoid or starter motor faulty.
Replace. Contact Sears Parts & Repair.
Safety interlock switch faulty.
Replace. Contact Sears Parts & Repair.
Engine starts
Air filter plugged
Service pre-cleaner and/or replace air filter ele-
hard or runs
ment.
poorly.
Choke not set to CLOSED position when
Set choke to CLOSED when cranking.
Set choke to
cranking the engine, OR choke not set to
OPEN when engine is running. A warm engine may
OPEN after engine starts,
not require choking.
Spark plug faulty, fouled, or incorrectly gapped.
Clean and gap or replace.
Engine
Low oil level.
Check/add oil as required.
knocks.
Using wrong grade oil.
See "Change Engine Oil" in the Maintenance
Section.
Excessive
oil
Engine running too hot.
Clean engine cooling fins, blower screen and air
consumption,
cleaner.
Using wrong weight oil.
See "Change Engine Oil" in the Maintenance
Section.
Too much oil in crankcase.
Drain excess oil.
Engine
Dirty air filter or precleaner, or both.
Service or replace as required.
See Maintenance
exhaust is
Section.
black.
Choke set to CLOSED when engine is running.
Set choke to OPEN as soon as engine starts.
33
Tabla de contenido
