Squeegee Cleaning; Weekly Maintenance; Rear Squeegee Rubber Replacement; Squeegee Hose Cleaning - Floorpul ruby 45e Manual De Uso Y Mantenimiento

GB
ATTENTION:
The execution of brushes disassembly operations
with electric supply on, may cause damages to hands.
ATTENTION:
The handling of the brushes operation must be car-
ried out using suitable gloves to protect both me-
chanically from contact with the bristles and the
chemical risk of contact with dangerous solutions.

SQUEEGEE CLEANING

Keeping the squeegee clean guarantees always the
best drying action.
For the cleaning it is necessary to:
1. Take off the squeegee hose (3) from the coupling.
2. Disassemble the squeegee from the support ro-
tating the lever (2) counterclockwise sliding the stud
bolts (1) in their slots.
3. Clean with care the internal part of the squeegee
inlet eliminating eventual dirt residuals.
4. Clean with care the squeegee rubbers.
5. Reassemble all parts.

WEEKLY MAINTENANCE

REAR SQUEEGEE RUBBER REPLACEMENT

Check the squeegee rubber wear and eventually turn
or replace it.
For the replacement it is necessary to:
1. Lift the squeegee acting upon the lever (11).
2. Uncouple the hook (1) of the rubber holder blade,
release the extremities (2) from the squeegee body
and take off the rubber (4).
3. Turn the rubber (4) to a new side or replace it.
To reassemble the squeegee repeat reverse the op-
erations above-mentioned, inserting the rubber (4)
on the guides (3), couple the extremities (2) of the
rubber holder blade onto the squeegee body and fi-
nally block the hook (1).

SQUEEGEE HOSE CLEANING

Weekly or in case of insufficient suction, it is neces-
sary to check that the squeegee hose is not ob-
structed. Eventually, to clean it, proceed as follows:
1. Take off the hose from the squeegee coupling (1)
and release the guide spring of the squeegee hose (2).
2. Wash the inside of the hose with a water jet,
from the squeegee hose side.
3. To reassemble the hose repeat reverse the opera-
tions above-mentioned.

CLEANING OF SOLUTION TANK AND FILTER

1. Bring the machine to an appropriate place for
tanks draining.
2. Unscrew the solution tank cap (1).
3. Unscrew the exhaust plug (2).
3a. The machines equipped with the optional device
of the solution drainage, it is sufficient to open the
solution valve of the device (see under "EMPTYING
DEVICE DETERGENT SOLUTION").
4. Rinse with a water jet the solution tank.
5. Rinse the solution tank filter placed inside the
exhaust plug, under the machine.
6. Reassemble all parts and close, if present, the so-
lution valve of the drainage device.
ATTENTION:
This operation must be carried out using gloves to
protect from contact with dangerous solutions.
20

TWO-MONTHLY MAINTENANCE

FRONT SQUEEGEE RUBBER REPLACEMENT

Check the wear of the squeegee rubber and eventu-
ally replace it.
For the replacement it is necessary to:
1. Take off the squeegee hose (3) from its coupling.
2. Disassemble the squeegee from the support ro-
tating the lever (2) counterclockwise and sliding the
stud bolts (1) in their slots.
3. Uncouple the hook (1) of the rubber holder blade,
release the extremities (2) from the squeegee body
and take off the rubber (4).
4. Unscrew the wing nuts (5) in the upper part of
the squeegee.
5. Slip off the lower part (6) of the squeegee body,
so to take off the front rubber (7).
GB