In the CT1X and CT1Xw, this setting is
valid also for the acoustic signal of the
warning notice (ch. 4.8 and 4.9).
Fig. 19: Volume of the CTx keyboard
4.12 P0.11 System Code
The system code allows you to protect the system
from cards not belonging to the same system. The
system code programmed in the CTx must be the
same as that memorized in the prepaid cards and
in the CARDWRITER-01 programmer, otherwise
the cards will be refused.
For more information, consult the instruction
manual of the CARDWRITER-01 programmer.
With the
and
system code.
Fig. 20: System Code
5
P
ROGRAMMING FOR EACH SERVICE
Following the common programming steps, there
are the specific programming steps for each
service.
The service to which each step refers is indicated
by the number in the upper right hand corner of the
display and by the first number of the programming
step (e.g. P1.3 is the third step of programming for
service 1).
To select the desired programming step, use the
and
buttons.
F
E
D
AVERO
LECTRONIC
ESIGN
buttons, set the CTx
Pag. 9 / 51
5.1 PX.0 Enabling service
Allows for the utilization of the service. If enabled, it
is possible to select and use the service.
Fig. 21: Enabling service
5.2 PX.1 Copy parameters from another
service
Select the number of the service from which you
wish to copy the parameter value. Confirm copy
status with the
This parameter returns automatically to 0 after
performing its function.
Fig. 22: Copy parameters from another service
5.3 PX.2 Base time
Set the time of service associated with the base
amount (ch
4.6). The pause time, which can be set
.
in subsequent steps, is not included.
The maximum value that can be set is 24 hours.
Fig. 23: Base time
00182-M01-02-ML - Manuale uso CTx
ENGLISH
button.