Milwaukee M18 HCC75 Manual Del Usuario página 9

USE
WARNING: To reduce the risk of explosions, electric shock and damage to property and equipment, never cut live
electrical cables.
Tool is NOT insulated. Contact with a live circuit could result in severe injury or death. Turn o power before making a cut.
Never cut gas or water lines. Keep hands away from all cutting edges and moving parts. Laceration and amputation can
occur.
Always remove battery pack before changing or removing accessories. Only use accessories speci cally recommended for
this tool. Others may be hazardous.
To reduce the risk of injury, wear safety goggles or glasses with side shields.
WARNING: To reduce the risk of injury, only cut recommended materials for the blades. (see „Speci cations") Do not
attempt to cut other materials.
The cutting head with a front hand-grip can be turned for optimal
use.
CUTTING
• Before cutting, ensure blades are properly installed.
• While in use, the tool can be set down on a dry subsurface or used as a handheld device. To stand the tool up on the ground, turn the cutting
head 180° so the front hand grip can be used as a base. If you want to use the tool as a handheld device, hold it securely using both handles
as shown.
1. Lay the cable cutter on the cable, with its cutting edge at right
angle, up to the inner cutting end. Do not attempt to make
angled cuts as it will damage the workpiece and blades.
2. Grasp handle(s) rmly. Move the slider switch into the
unlocked position. (1)
Pull and hold the trigger through the operation. (2)
An LED will light when the trigger is pulled.
When the cut is complete or the tool shuts o , release the
trigger.
Note: Workpiece may move slightly during the cut.
Deutsch
1
GB
> 340°
2
English
7