Specified Conditions Of Use - Milwaukee M18 HCC75 Manual Del Usuario

SPECIFIED CONDITIONS OF USE

The cable cutter is suitable for cutting insulated copper and alu-
minum cables and cables with light reinforcement that have been
disconnected from the power supply, depending on the cable type.
Cutting and splitting of cables with the aid of this cable cutter may
only carried out by personnel trained to work on underground
cables in accordance with local regulations.
The operator of this cable cutter must be instructed in the speci c
dangers associated with using this cable cutter and in the essential
safety measures before working with it for the rst time and at
least once a year thereafter.
USE
4
3
2
1
GB
Device description
1 Blade retainer
2 Blades
3 Front handle
4 Slide switch / Trigger lock
5 LED
6 Trigger
7 Release trigger
8 Handle
9 ONE-KEY battery door
10 Safety eyelet
11 Battery
English
Deutsch
6
5
6
8
7
9
10
The operating company must:
• make the operating manual available to the operator and
• ensure that the operator has read and understood it.
WARNING Read all safety warnings, instructions, illus-
trations and speci cations provided with this device. Failure
to follow the warnings and instructions may result in electric shock,
re and/or serious injury.
Save all warnings and instructions for future reference.
Set-up of the working area
Before work begins, the cables must be disconnected and it must
be ensured that they remain de-energized throughout the work.
Local safety provisions and the regulations of the network operator
must be observed under all circumstances.
To a ect, ensure and maintain disconnection of the power supply,
contact the network operator.
If it cannot be ensured beyond doubt that the cable or insulated line
11
has been disconnected, no work may be carried out.
Before the cutting process begins, access must be sealed o and
monitored in accordance with local regulations.
Do not expose tools to rain. Do not use tools in damp or wet
locations.
Preparation of cable cutter and battery
Before every use:
• Inspect cable cutter for external defects
• Check the cutting tool for cracks and other signs of wear
Only use in perfect condition!
Before the cutting process begins, the battery capacity must be
checked: minimum 33% (see illustrated description).
It may require charging before work commences.
Preparation for the cutting process
Support and x the cable to be cut in order to minimize the risk of
uncontrolled movement.
Overhead cables, in particular, can move out of control and cause
injury and/or damage.
The cutting head must be positioned at an angle of 90° to the cable
so that the cable can lie in the open cutting jaws without tension
and undesirable shearing forces can be avoided.