Service And Maintenance; Environment - Festool MX 1200 RE EF HS3R Instrucciones De Servicio Originales

If required, you can extend the flexible power
cable as follows:
– Length 20 m, conductor cross-section
3×1.5 mm
2
– Length 50 m, conductor cross-section
3×2.5 mm
2
Only use extension cables that are suitable for
outside use and that are marked accordingly.
Operating with electric generator (EG) with
combustion motor drive
The manufacturer of the stirrer does not
provide any guarantee for incorrect opera­
tion of the stirrer with any EG.
The stirrer can be operated with an EG if the
following conditions are met:
– The output voltage of the EG must always
be within the range of 230 VAC ±10% , the
EG must be equipped with Automatic Volt­
age Regulation (AVR). The stirrer must not
work correctly without this regulation and
may also become damage.
– The power of the EG must be at least 2.5
times greater than the connected load of
the stirrer (i.e. 2.5 kW for MX 1000 RE EF,
3 kW for MX 1200 RE EF)
– If you operate using an EG that does not
have sufficient power, the speed may fluc­
tuate and the power of the machine may
decrease.
7

Service and maintenance

CAUTION
Never use a machine that is damaged in any
way! (Damage also includes a ripped or worn
flexible switch protection or clamping ring
protection on the ErgoFix adapter).
► Have a damaged machine repaired in an
authorised Festool workshop.
WARNING
Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must only be
carried out by the manufacturer or service
workshops. Find the nearest address at:
www.festool.co.uk/service
EKAT
4
5
3
2
1
Always use original Festool spare parts. Order
no. at:
www.festool.co.uk/service
– The ventilation holes [1-6] on the motor
hood must not be blocked.
– The machine automatically switches off if
the carbon brushes are worn. The machine
must be sent to the workshop for mainte­
nance work.
– We recommend that you clean the ma­
chine regularly. Remove any dust, residual
mixing material and any other dirt. If you
use solventbased cleaning agents, these
may damage the painted surfaces or the
plastic parts. If you use these cleaning
agents, we recommend that you test the ef­
fect of these agents on a small, concealed
area. The ventilation holes on the motor
hood must not be blocked.
Commission an authorised workshop to
–
change brushes, the power cable etc..If
the machine is knocked in any way, it is al­
so necessary to entrust an authorised
workshop in order to prevent any mechani­
cal or electrical danger arising.
– The packaged machine can be stored in a
dry place without heating as long as the in­
side temperature does not fall below -5 °C.
The unpackaged machine must only be
stored in a dry, enclosed space where the
temperature does not fall below +5 °C and
where no extreme temperature fluctua­
tions occur.
8

Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
English
19