HJM CP136 Instrucciones De Uso página 32

Centro Planchado CP136_Maquetación 1 01/03/16 09:53 Página 32
Press the boiler's switch (4) and wait for the water to start boiling
(about 8 minutes). Next, press switch (5) to turn on the iron and then
select the desired temperature by means of the thermostat knob (9).
When the light (11) goes off, the set temperature has been reached
and the iron is ready for use. It takes about 8minutes for the boiler to
reach the optimum Ironing pressure.
When the appliance is ready for use the steam pilot lamp (6) lights up.
When using the iron for the first time, iron a plain cloth first.
To obtain steam, press the steam button (10).Release the steam but-
ton when steam is no longer required.
This appliance is also able to generate steam in a vertical position
and can therefore be used to refresh fabrics easily with a jet of
steam.
Attention: never allow the steam to flow out of the iron whilst it
is resting on the stand provided (7). If the jet of steam decreases
while you are ironing, the boiler tank is running out of water.
Attention: the boiler is always under pressure!
How to fill the boiler while the appliance is being used
To continue ironing. Top up as follows:
- Switch off the boiler(4). Select the desired temperature "MIN" by
turning the thermostat knobs (9).
- Release the pressure left in the boiler, keeping the steam but-
ton(10) on the iron pressed down until no more steam comes out of
the plate. Then switch off the iron (5).
- Unplug the power cord from the wall socket.
- Wait for the iron and the boiler to cool down.
- Unscrew the cap and wait a few minutes.
- Slowly pour 1.0 litres of water into the opening (fig.2) always using
the funnel provided.
- Close the boiler and fully tighten the cap.
- Press the boiler switch(4).
- Wait for steam pilot lamp (6)to light up before continuing ironing.
CAUTION! Never attempt to open the cap while the boiler is under
pressure.
Never unscrew the boiler cap when the appliance is connected
to the outlet.
- 32 -
E
N
G
L
I
S
H