Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TE-MX 18 Li-Solo Manual De Instrucciones

5.3 Fitting the stirrer (Fig. 4-5):
Screw the two parts of stirrer, part (6a) and part
(6b) tightly together. Then screw the stirrer (6) into
the stirrer mount (4). Use two open-ended span-
ners to do so. Use one open-ended spanner (5a)
to hold the stirrer mount (4) fi rmly while tightening
the stirrer (6) with the other open-ended spanner
(5b). To remove the stirrer, proceed in reverse
order.
6. Operation
6.1 On/Off switch (Fig. 6/Item 1)
Switching on:
Press the locking button (3) and the On/Off switch
(1).
Switching off :
Release the locking button (3) and the On/Off
switch (1).
6.2 Speed controller (Fig. 7/Item 2)
You can select the speed by turning the speed
controller (2). You can choose from 6 speed set-
tings.
Plus direction: Higher speed
Minus direction: Lower speed
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
We recommend that you clean the device
immediately each time you have finished
using it.
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
GB
7.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
7.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.4 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
www.sidirika-nikolaidi.gr
- 18 -
the risk of an electric shock.
Type of unit
Article number of the unit
ID number of the unit
Spare part number of the required spare part
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
[email protected]
!