Using The Thermostat - S&P RADIANT-1500 Instrucciones De Uso

selected.
- The thermostat maintains the ambient temperature required by switching the equipment on and off
automatically. The more the thermostat knob is turned clockwise to a position with a higher number,
the higher the temperature ensured. The maximum thermostat position corresponds to about 35°C,
while the minimum (*) is about 5°C.
- WARNING! When the switch knob is at the maximum position (pos. II) do not turn it further clockwise.
- WARNING! When the thermostat knob is at the maximum position (pos. MAX) do not turn it further
clockwise.
- When the product is working, slight undulations may occur on the surface of the heating ele-
ment inside the product. This is completely normal and does not affect correct functioning of
the equipment or its reliability over time.

6.2 Using the thermostat

- In a room in which the temperature exceeds 35°C it is normal that, even when turned to maximum,
the product does not switch on.
- On the contrary, in a room in which the temperature is too low (below 5°C) it is normal that, even when
turned to minimum, the thermostat will keep the equipment switched on all the time.
- To make the best thermostat setting, we recommend the following:
• Put the thermostat on maximum and allow the equipment to run until a comfortable temperature
is reached.
• Then turn the thermostat knob anticlockwise until you hear a "click", and the equipment swit-
ches off.
• Then turn the thermostat knob clockwise again (only a little).
• In this position the thermostat will maintain the ambient temperature you have chosen.
- When the product is working and heating the space, the relevant signal LED switched on.
7. SAFETY IN CASE OF ABNORMAL OPERATION
- If the product overheats the protection system will automatically deactivate the heating elements and
switch off the equipment.
- If this happens:
• Turn the thermostat knob clockwise to check that the thermostat has not simply switched off the
equipment because a high ambient temperature has been reached.
• If the product does not start working normally again:
• Switch off the equipment
• Remove whatever is causing the overheating (e.g. obstructions at the air intake or air outlet grilles).
• Allow the product to cool for 15 – 20 minutes.
• Switch the product on again.
8. MAINTENANCE
- This product does not require specific maintenance.
- Every six months we suggest removing any dust that has accumulated on the coil using a vacuum
cleaner.
- If you need any assistance, contact an authorised assistance centre.
- If you have to change the power supply cable, remember that you have to use an HAR 2 x 1 mm2
H05RR-F or H05RN-F model cable.
9. TECHNICAL ASISTANCE
S&P's large Technical Service network will guarantee adequate technical assistance.
If a fault is observed in the unit, please contact any of the mentioned technical service offices and they
will attend to your problem.
Any manipulation of the appliance by personnel not belonging to the Official S&P Services will result in
your guarantee being void.
For any queries regarding S&P products please contact any branch of our After Sales Service network
if you are in Spain, or your regular dealer in the rest of the world.
14