Wall Mounting; Using The Equipment - S&P RADIANT-1500 Instrucciones De Uso

- The regulating knobs must never be accessible to people in a bath or shower.
- The product must be free to take air in and expel it.
- For portable use:
• Assemble the pedestal by screwing the rod (figure 1/D) to the base (figure 1/C) with the 2 coun-
tersunk screws supplied (fig 5).
• Insert the pedestal rod in the relevant rectangular slot that can be seen in the lower grille on the
product (figure 6).
• Fix the pedestal to the product using the 4 screws supplied at the points indicated in figure 7.
- This product has double electrical insulation and does not require an earth connection.

4. WALL MOUNTING

- The product can be wall mounted only if the pedestal is not fitted and respecting the distances shown
in figure 3.
- Screw the product to the lower support bracket as shown in figure 8 using the screws supplied.
- Fix the wall bracket by making 2 holes in the wall 150 mm apart, using a 6 mm drill bit. Insert the 2
wall anchors and fix the wall bracket using the 2 screws supplied as shown in figure 9.
- Hook the product to the wall bracket first pushing it towards the wall and then making it click in
downwards (figure 10).
- Use a pencil to mark the point at which to drill the hole for fixing the lower support, remove the pro-
duct, drill the hole in the wall using a 6 mm drill bit, and insert the wall anchor supplied (fig 11).
- Hook the product to the plastic bracket again and fix the lower bracket using the relevant screws.
- IMPORTANT FOR FRANCE:
If the product is to be wall mounted the electrical connection to the power supply must be done by
cutting off the plug supplied and using a suitable terminal as per the diagram shown below:
Electricity
In wet spaces like bathrooms or kitchens, the connection terminal must be installed at least 25 cm abo-
ve the floor. The electrical connection to the power supply must also be fitted with a two-pole switch
with a minimum gap between the contacts that allows complete disconnection according to excess
voltage III category conditions.
5. CABLE WINDER
- When the product is not in use the cable can be coiled as shown in figure 12.
- Remember that when using the product the cable must be completely uncoiled.

6. USING THE EQUIPMENT

6.1 Power and thermostat selector (figure 13)
- This model has 2 knobs, one for adjusting the operating power and one for the thermostat.
- The power regulator can be used to select 3 different operating modes for the product:
- Turn the thermostat knob clockwise until you hear a "click". The product starts working at the power
selected.
- The thermostat maintains the ambient temperature required by switching the equipment on and off
automatically. The more the thermostat knob is turned clockwise to a position with a higher number,
the higher the temperature ensured. The maximum thermostat position corresponds to about 35°C,
while the minimum (*) is about 5°C.
Phase = brown
Neutral = blue
O = OFF
I = 750 W OPERATION
I I = 1500 W OPERATION
13
Product's cable