Assembly
Setting the lathe on the leg set (Fig 3)
1. Place the lathe bed assembly [1] on the leg set.
2. Position the headstock [2] assembly over the top
plate and align the holes in the bed [3] with the holes
in the top plate [4]. Set the headstock down carefully.
3. Align the tailstock assembly end of the lathe over the
top plate mounting holes and set it down carefully.
4. Insert the hex bolts [5] into the mounting
holes in each bed and tighten securely.
IMPORTANT! THE LEG SET MUST BE FASTENED TO THE SUPPORTING SURFACE.
Faceplate (Fig 4)
1. Remove the headstock spur from the spindle.
2. Thread the 6 inch diameter faceplate to the Spindle.
3. Mount the workpiece to the faceplate with the flat
head brass wood screws. Make sure the length of the
screws does not interfere with the cutting tools.
EN
1. Lathe bed assembly
2. Face plate
3. Headstock spur center
4. Tailstock cup center
5. Push rod
6. Flat wrenches
7. Hex key
8. Instruction panel
9. Hex bolt
10. Front leg & rear leg
5