Using The Remote Control - Sharp AY-XPC7JR Manual De Instrucciones

USING THE REMOTE CONTROL

LOADING BATTERIES
Use two size-AAA (R03) batteries.
1
Remove the remote control cover.
2
Insert batteries in the compartment,
making sure the (+) and (-) polarities
are correctly a lign ed.
• The display indicates "AM 6:00" when
batteries are properly installed.
3
Reinstall the cover.
Remote
control cover
NOTE:
• The battery life is approximately one year in
normal use.
• When you replace the batteries, always change
both batteries, and make sure they are the same
type.
• If the remote control does not operate properly
after replacing the batteries, take out the batteries
and reinstall them again after 30 seconds.
• If you will not be using the unit for a long time,
remove the batteries from the remote control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the unit's signal
receiver window and press the desired button. The
unit generates a beep when it receives the signal.
• Make sure there is no curtain or other object
between the remote control and the unit.
• The remote control can send signals from up to 7
metres away.
CAUTION:
• Do not allow the signal receiver window to receive
strong direct sunlight, since it can adversely affect
its operation. If the signal receiver window is
exposed to direct sunlight, close a curtain to block
the light.
• Using a fl uorescent lamp with a quick starter in
the same room may interfere with transmission of
the signal.
• The unit can be affected by signals transmitted
from the remote control of a television, VCR or
other equipment used in the same room.
• Do not leave the remote control in direct sunlight
or near a heater. Also, protect the unit and remote
control from moisture and shock which can
discolour or damage them.
SET CURRENT CLOCK TIME
There are two clock modes: 12-hour mode and
24-hour mode.
Example: 5 o'clock in the afternoon
Clock
12-hour mode
24-hour mode
1
To set to the 12-hour mode, press the
CLOCK button once in the fi rst step.
To set to the 24-hour mode, press the
CLOCK button twice in the fi rst step.
2
Press the TIME ADVANCE or REVERSE
button to set the current time.
• Keep the button pressed to advance or
reverse the time display quickly.
3
Press the SET/C button.
• The colon (:) blinks to indicate that the clock
is functioning.
NOTE:
• The current time cannot be set when the timer is
operating.
GB-4
Display
PM 5:00
17:00
2
3
1